|
|
– Cut back the remaining material on the body flange using the Window Cutter - U Blade (2 pc.) - VAG1561/3- , but do not remove all residue under any circumstance. Note The remaining material acts as a base for the new adhesive to be applied. Keep the adhesive surfaces free of dirt and grease. WARNING Exception: If the bonding is going to be performed longer than one day after cutting back the adhesive bead, then the remain‐ ing material must be activated with the activator. Refer to the Parts Catalog. Refer to the Parts Catalog. wise this will damage the paint. ♦ If the body flange is being repaired or partially replaced, the corresponding area must be cleaned and primed again before painting. Note It is possible that the laser weld seam does not lie in the area of the adhesive bead. In this case, the open weld seam must be sealed with window adhesive before bonding the window. – If the laser weld seam -3- on the body panel flange -4- is not covered by the adhesive bead -1-, coat the laser weld seam -3- with the glass/paint primer -3-. Refer to the Parts Catalog. Afterward, fill the laser weld seam with window adhesive -1-. Refer to the Parts Catalog. Paint Damage, Repairing to the “Paint” repair manual specifications. 1.7 Adhesive, Removing – As cleaning solution use the adhesive remover. Refer to the Parts Catalog. Follow all safety precautions. WARNING When cleaning the vehicle interior, the window just installed may not be pressed outward. – Clean the painted surface with a dry cloth. Remove residual adhesive with adhesive remover. Refer to the Parts Catalog. |