|
|
Content .. 1276 1277 1278 1279 ..
ENGINE MECHANICAL 6A – 45 Cylinder Liner Bore Measurement Use a cylinder indicator to measure the cylinder liner bore in the thrust – and axial – directions of the crankshaft. 20mm (0.79 in) If the measured value exceeds the specified limit, the cylinder NOTE: The inside of the dry type cylinder liner is chrome plated. It Cylinder Liner Grade Selection Measure the cylinder body inside diameter and select the If the cylinder liner fitting interference is too small, engine NOTE: There are two methods by which liners can be selected. Method I The cylinder block deck has been marked during production Method II Cylinder Body Bore Measurement 1) Take measurements at measuring point (A) across – , – , – , and – . Measuring Point (A) 98 mm (3.86 in). 1 2 2 3 3 1 1 1 2 2 3 3 4 4 0.001 – 0.019 (0.0004 – 0.0007) mm (in.) Standard Fifting Interference |