Nissan Rogue. Manual - part 620

NORMAL OPERATING CONDITION

EXL-109

< SYMPTOM DIAGNOSIS >

[HALOGEN HEADLAMP]

C

D

E

F

G

H

I

J

K

M

A

B

EXL

N

O

P

NORMAL OPERATING CONDITION

Description

INFOID:0000000011280769

AUTO LIGHT SYSTEM

The headlamp may not be turned ON/OFF immediately after passing dark area or bright area (short tunnel,

sky bridge, shadowed area, etc.) while using the auto light system. This is caused by the control difference.

This is normal.

EXL-110

< SYMPTOM DIAGNOSIS >

[HALOGEN HEADLAMP]

BOTH SIDE HEADLAMPS (HI) ARE NOT TURNED ON

BOTH SIDE HEADLAMPS (HI) ARE NOT TURNED ON

Description

INFOID:0000000011280770

Both side headlamps (HI) are not turned ON when setting to the lighting switch HI or PASS.

Diagnosis Procedure

INFOID:0000000011280771

1.

COMBINATION SWITCH INSPECTION

Check combination switch. Refer to 

BCS-73, "Symptom Table"

 (with Intelligent Key system) or 

BCS-133,

"Symptom Table"

 (without Intelligent Key system).

Is the inspection result normal?

YES

>> GO TO 2.

NO

>> Repair or replace the malfunctioning part.

2.

CHECK HEADLAMP (HI) REQUEST SIGNAL INPUT

CONSULT DATA MONITOR

1. Select “HEADLAMP (HI)” in “Data Monitor” of “IPDM E/R”.

2. With operating the lighting switch, check the monitor status.

Is the inspection result normal?

YES

>> GO TO 3.

NO

>> Replace BCM. Refer to 

BCS-75, "Removal and Installation"

 (with Intelligent Key system) or 

BCS-

135, "Removal and Installation"

 (without Intelligent Key system).

3.

HEADLAMP (HI) CIRCUIT INSPECTION

Check headlamp (HI) circuit. Refer to 

EXL-100, "DTC Logic"

 (LH) or 

EXL-101, "DTC Logic"

 (RH).

Is the inspection result normal?

YES

>> Refer to 

GI-44, "Intermittent Incident"

.

NO

>> Repair or replace the malfunctioning part.

Monitor item

Condition

Monitor status

HEADLAMP (HI)

Lighting switch

(2ND)

HI or PASS

On

LO

Off

BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON

EXL-111

< SYMPTOM DIAGNOSIS >

[HALOGEN HEADLAMP]

C

D

E

F

G

H

I

J

K

M

A

B

EXL

N

O

P

BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON

Description

INFOID:0000000011280772

Both side headlamps (LO) are not turned ON in any condition.

Diagnosis Procedure

INFOID:0000000011280773

1.

CHECK COMBINATION SWITCH

Check combination switch. Refer to 

BCS-73, "Symptom Table"

 (with Intelligent Key system) or 

BCS-133,

"Symptom Table"

 (without Intelligent Key system).

Is the inspection result normal?

YES

>> GO TO 2.

NO

>> Repair or replace the malfunctioning part.

2.

CHECK HEADLAMP (LO) REQUEST SIGNAL INPUT

CONSULT DATA MONITOR

1. Select “HEADLAMP (LO)” in “Data Monitor” of “IPDM E/R”.

2. With operating the lighting switch, check the monitor status.

Is the inspection result normal?

YES

>> GO TO 3.

NO

>> Replace BCM. Refer to 

BCS-75, "Removal and Installation"

 (with Intelligent Key system) or 

BCS-

135, "Removal and Installation"

 (without Intelligent Key system).

3.

HEADLAMP (LO) CIRCUIT INSPECTION

Check headlamp (LO) circuit. Refer to 

EXL-102, "DTC Logic"

 (LH) or 

EXL-103, "DTC Logic"

 (RH).

Is the inspection result normal?

YES

>> Refer to 

GI-44, "Intermittent Incident"

.

NO

>> Repair or replace the malfunctioning part.

Monitor item

Condition

Monitor status

HEADLAMP (LO)

Lighting switch

2ND

On

OFF

Off

EXL-112

< SYMPTOM DIAGNOSIS >

[HALOGEN HEADLAMP]

PARKING, LICENSE PLATE, SIDE MARKER AND TAIL LAMPS ARE NOT 

TURNED ON

PARKING, LICENSE PLATE, SIDE MARKER AND TAIL LAMPS ARE NOT
TURNED ON

Description

INFOID:0000000011280774

The parking, license plate, side marker, tail lamps and each illumination are not turned ON in any condition.

Diagnosis Procedure

INFOID:0000000011280775

1.

COMBINATION SWITCH INSPECTION

Check combination switch. Refer to 

BCS-73, "Symptom Table"

 (with Intelligent Key system) or 

BCS-133,

"Symptom Table"

 (without Intelligent Key system).

Is the combination switch normal?

YES

>> GO TO 2.

NO

>> Repair or replace the malfunctioning part.

2.

CHECK TAIL LAMP REQUEST SIGNAL INPUT

CONSULT DATA MONITOR

1. Select “TAIL LAMP” in “Data Monitor” of “IPDM E/R”.

2. With operating the lighting switch, check the monitor status.

Is the inspection result normal?

YES

>> Replace IPDM E/R. Refer to 

PCS-40, "Removal and Installation"

.

NO

>> Replace BCM. Refer to 

BCS-75, "Removal and Installation"

 (with Intelligent Key system) or 

BCS-

135, "Removal and Installation"

 (without Intelligent Key system).

Monitor item

Condition

Monitor status

TAIL LAMP

Lighting switch

1ST

On

OFF

Off