|
|
EC-314 < DTC/CIRCUIT DIAGNOSIS > [VQ40DE] P0448 EVAP CANISTER VENT CONTROL VALVE 2. Check portionof B EVAP canister vent control valve for being rusted. If NG, replace EVAP canister vent control valve. If OK, go to next step. 3. Reconnect harness connectors disconnected. 5. Perform “VENT CONTROL/V” in “ACTIVE TEST” mode. Make sure that new O-ring is installed properly. Operation takes less than 1 second. If NG, go to next step. 7. Clean the air passage (portion A to B) of EVAP canister vent control valve using an air blower. Without CONSULT 1. Remove EVAP canister vent control valve from EVAP canister. rusted. 3. Check air passage continuity and operation delay time under the following conditions. Make sure that new O-ring is installed properly. Operation takes less than 1 second. If NG, go to next step. 4. Clean the air passage (portion A to B) of EVAP canister vent control valve using an air blower. PBIB1033E Condition VENT CONTROL/V Air passage continuity between (A) and (B) ON No OFF Yes PBIB1033E Condition Air passage continuity between (A) and (B) 12V direct current supply between No OFF Yes PBIB1034E |