|
|
FSU-10 < REMOVAL AND INSTALLATION > FRONT COIL SPRING AND STRUT Disassembly and Assembly INFOID:0000000008459215 DISASSEMBLY CAUTION: Never damage strut assembly piston rod when removing components from strut assembly. 1. Install strut attachment (A) [SST: ST35652000 ( — )] to strut assembly and secure it in a vise. CAUTION: When installing the strut attachment to strut assembly, 2. Using a spring compressor (A) (commercial service tool), com- CAUTION: Be sure a spring compressor is securely attached to coil 3. Make sure coil spring with a spring compressor between strut 4. Remove strut mounting insulator and strut mounting bearing, 5. After removing coil spring with a spring compressor (commercial service tool), then gradually release a CAUTION: Loosen while making sure coil spring attachment position does not move. 6. Remove lower rubber seat from strut. 7. Remove the strut attachment [SST: ST35652000 ( — )] from strut. ASSEMBLY 1. Install strut attachment [SST: ST35652000 ( — )] to strut and secure it in a vise. CAUTION: When installing the strut attachment to strut assembly, wrap a shop cloth around strut to protect 2. Install lower rubber seat. 3. Install bound bumper onto strut mounting insulator. 4. Compress coil spring using a spring compressor (commercial service tool), and install it onto strut assem- CAUTION: • Face tube side of coil spring (1) downward. Align the lower end (A) to lower rubber seat (2). • Be sure a compressor is securely attached to coil spring. Compress coil spring. • Set coil spring so that its paint marks are aligned with the positions of 1.25 turns and 2.25 turns from the bottom end JPEIA0006ZZ JPEIA0168ZZ JPEIA0095ZZ Revision: 2012 September 2013 MURANO |