Infiniti FX35 / FX45. Manual - part 218

 

  Index      Infiniti     Infiniti FX35 / FX45 (S50) - service repair manual 2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  216  217  218  219   ..

 

 

Infiniti FX35 / FX45. Manual - part 218

 

 

REAR DOOR LOCK

BL-139

< SERVICE INFORMATION >

C

D

E

F

G

H

J

K

L

M

A

B

BL

N

O

P

Do not forcibly remove the TORX bolt.

5.

While pulling the outside handle, remove outside handle
escutcheon.

6.

While pulling outside handle, slide toward rear of vehicle to
remove outside handle.

7.

Remove the front gasket and rear gasket.

8.

Remove the TORX bolt, and remove the outside handle bracket.

PIIA3553E

PIIA6344E

PIIA3555E

PIIA3557E

PIIA7117E

BL-140

< SERVICE INFORMATION >

REAR DOOR LOCK

9.

While pulling outside handle, slide toward front of vehicle to
remove outside handle bracket.

10. Reach to separate outside handle cable connection.

11. Remove the TORX bolts of door lock assembly.

12. Disconnect the door lock actuator connector and remove door lock assembly.

INSTALLATION

Install in the reverse order of removal.

CAUTION:

To install each rod, be sure to rotate the rod holder until a click is felt.

PIIA3558E

PIIA5059E

PIIB5812E

BACK DOOR

BL-141

< SERVICE INFORMATION >

C

D

E

F

G

H

J

K

L

M

A

B

BL

N

O

P

BACK DOOR

Fitting Adjustment

INFOID:0000000001327879

VERTICAL/LATERAL CLEARANCE ADJUSTMENT

1.

With the striker released, loosen the bumper rubber lock nuts.

2.

Close the back door lightly and adjust the surface height by rotating the bumper rubber and, then open the
back door to finally tighten the back door lock mounting bolts and bumper rubber lock nuts to the specified
torque.

Back Door Assembly

INFOID:0000000001327880

REMOVAL

1.

Remove roof rear garnish assembly. Refer to 

EI-45, "Component Parts Location"

.

2.

Disconnect the back door harness connector and AV antenna
feeder.

3.

Washer hose is separated in the connection part.

1.

Bumper rubber

2.

Back door striker

3.

Screw

PIIB0208E

PIIA6028E

BL-142

< SERVICE INFORMATION >

BACK DOOR

4.

Support the back door lock with a proper material to prevent it
from falling.

WARNING:

Body injury may occur if no supporting rod is holding the
back door open when removing the damper stay.

5.

Remove back door stay on back door.

6.

Remove back door hinge mounting nuts on the back door and
remove back door assembly.

INSTALLATION

Install in the reverse order of removal.

CAUTION:

• After installing, check operation.
• After installing, perform fitting adjustment. Refer to 

BL-141, "Fitting Adjustment"

.

INSPECTION

1.

Check back door hinges for the following.
• Malfunction noise or door closing and opening effort
• Component wear or damage

2.

Apply body grease to the rotating part of the back door hinge.

Removal and Installation of Back Door Striker

INFOID:0000000001327881

REMOVAL

PIIA6061E

PIIA6029E

PIIA6030E

PIIA6030E

 

 

 

 

 

 

 

Content   ..  216  217  218  219   ..