Chrysler 300/300 Touring/300C, Dodge Magnum. Manual - part 1974

 

  Index      Chrysler     Chrysler 300/300 Touring/300C, Dodge Magnum - service repair manual

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  1972  1973  1974  1975   ..

 

 

Chrysler 300/300 Touring/300C, Dodge Magnum. Manual - part 1974

 

 

SEAL-OUTPUT SHAFT

REMOVAL

1. Remove the propeller shaft (Refer to 3 - DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT/PROPELLER

SHAFT - REMOVAL). Move propeller shaft to the right and tie up.

2. Verify that the transmission is in PARK in order to prepare for the removal of the output shaft nut.

3. Remove the nut, with a 30 mm 12 point socket, holding the propeller shaft flange to the output shaft and remove

the flange.

4. Remove the output shaft seal with suitable screw and slide hammer.

INSTALLATION

1. Position the new output shaft seal over the output

shaft and against the transmission case.

2. Use Seal Installer 8902A (1) to install the seal.

3. Verify that the transmission is in PARK in order to

prepare for the installation of the output shaft nut.

4. Install the propeller shaft flange onto the output

shaft and install an new flange nut. Tighten the
flange nut, with a 30 mm 12 point socket, to 200
N·m (147.5 ft.lbs.).

5. Stake the output shaft nut to the output shaft as

follows.Place the Staking Tool 9078 (2) and Driver
Handle C-4171 onto the output shaft.

6. Rotate the Staking Tool 9078 (2) until the alignment

pin (3) engages the output shaft notch (4).

21 - 430

AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION

LX

7. Press downward on the staking tool until the stak-

ing pin (3) contacts the output shaft nut flange (2).

8. Strike the Driver handle C-4171 with a suitable

hammer until the output shaft nut is securely
staked to the output shaft.

9. Install the propeller shaft (Refer to 3 - DIFFEREN-

TIAL &

DRIVELINE/PROPELLER

SHAFT/PRO-

PELLER SHAFT - INSTALLATION).

LX

AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION

21 - 431

CABLE-PARK LOCK

REMOVAL

1. Place ignition key in the ACC (2) position.

2. Remove the lower instrument panel trim as neces-

sary to access the park lock cable.

3. Disconnect park lock cable (4) from ignition cylin-

der (3).

21 - 432

AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION

LX

4. Remove the floor console as necessary for access

to the park lock cable. (Refer to 23 - BODY/INTE-
RIOR/FLOOR CONSOLE - REMOVAL)

5. If necessary, remove the bolts holding the shield,

covering the gearshift and park lock cables, to the
floorpan and remove the shield.

6. Disconnect the park lock cable from the shift mech-

anism.

Release

retention

tab

using

suitable

screwdriver.

INSTALLATION

1. Verify that ignition key is in ACC (2) position.

LX

AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION

21 - 433

 

 

 

 

 

 

 

Content   ..  1972  1973  1974  1975   ..