|
|
Content .. 1262 1263 1264 1265 ..
Fig. 18: Clutch Pedal Position Switch Electrical Connector 3. Connect the clutch pedal position switch electrical connector (1). CLUTCH PILOT BEARING REPLACEMENT Tools Required J 43276 Clutch Pilot Bearing Remover
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Clutch - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
J 38836 Bushing Installer/Clutch Arbor. See Special Tools. Removal Procedure Fig. 19: Removing Clutch Pilot Bearing Using J 43276 1. Remove the clutch assembly. Refer to Clutch Assembly Replacement. 2. Using J 43276 perform the following in order to remove the clutch pilot bearing: NOTE: When using the J 43276 Clutch Pilot Bearing Remover, always IMPORTANT: The flywheel spacer (if applicable) must be removed prior to clutch pilot bearing removal.
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Clutch - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
1. Install the J 43276-1 into the clutch pilot bearing. 2. Using a wrench, secure the J 43276-1. 3. Insert the J 43276-2 into the J 43276-1. 4. Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft. 5. Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1. 6. Remove the J 43276-1 from the tool body.
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Clutch - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|
|
|