|
|
(1) Start the engine and idle it. NOTICE: Check that electrical systems such as the air conditioning system, audio system and lighting system are off. (2) Move the shift lever through the entire gear range to circulate the fluid. (3) Wait for 30 seconds with the engine idling. (4) Stop the engine. (5) Remove the refill plug. (6) Fill the transmission with the remaining fluid until the amount in the table has been filled. (7) Install the refill plug. 3. FLUID TEMPERATURE CHECK NOTICE: The ATF temperature can be confirmed by using the Techstream. (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON. (d) Enter the following menus: Powertrain / ECT / Data List / A/T Oil Temperature 1. (e) Check the ATF temperature. NOTICE: If the ATF temperature is higher than 59°C (138°F), turn the ignition switch off and wait until the fluid temperature drops to between 53 and 59°C (127 and 138°F). 4. FLUID LEVEL CHECK NOTICE: It is necessary to change to temperature detection mode in order to idle the vehicle appropriately. (a) When using the Techstream: Enter the following menus: Powertrain / ECT / Active Test / Connect the TC and TE1. Standard condition: Indicator lights in the combination meter blink. (b) When not using the Techstream: Standard condition: Indicator lights in the combination meter blink. (c) Start the engine and idle it. NOTICE: A760F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISS... |