|
|
DLK-330 < DTC/CIRCUIT DIAGNOSIS > CHILD LOCK STATUS SWITCH CHILD LOCK STATUS SWITCH SLIDING DOOR LH SLIDING DOOR LH : Component Function Check INFOID:0000000009649268 1. CHECK FUNCTION 1. Select “AUTO SLDE DOOR” using CONSULT. 2. Select “CHILD LOCK SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Child lock status switch is OK. NO >> Refer to DLK-330, "SLIDING DOOR LH : Diagnosis Procedure" SLIDING DOOR LH : Diagnosis Procedure INFOID:0000000009649269 1. CHECK CHILD LOCK STATUS SWITCH INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect remote control assembly LH connector. 3. Check voltage between remote control assembly LH harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> GO TO 2. 2. CHECK CHILD LOCK STATUS SWITCH CIRCUIT 1. Disconnect sliding door control unit LH connector. 2. Check continuity between sliding door control unit LH harness connector and remote control assembly LH 3. Check continuity between sliding door control unit LH harness connector and ground. Is the inspection result normal? YES >> Replace sliding door control unit LH. Refer to DLK-500, "LH : Removal and Installation" NO >> Repair or replace harness. 3. CHECK CHILD LOCK STATUS SWITCH GROUND CIRCUIT 1. Disconnect sliding door control unit LH connector. 2. Check continuity between sliding door control unit LH harness connector and remote control assembly LH Monitor item Condition Status CHILD LOCK SW Child lock LH LOCK OFF UNLOCK ON (+) (–) Voltage Remote control assembly LH Connector Terminal D118 4 Ground 8 – 16 V Sliding door control unit LH Remote control assembly LH Continuity Connector Terminal Connector Terminal B45 20 D118 4 Existed Sliding door control unit LH Ground Continuity Connector Terminal B45 20 Not existed |