|
|
ENCODER CIRCUIT PWC-29 < DTC/CIRCUIT DIAGNOSIS > C D E F G H I J L M A B PWC N O P Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace harness. 3. CHECK ENCORDER POWER SUPPLY CIRCUIT 1. Connect power window main switch connector. 2. Turn ignition switch ON. 3. Check voltage between front power window motor (driver side) harness connector and ground. Is the inspection result normal? YES >> GO TO 4. NO >> GO TO 5. 4. CHECK GROUND CIRCUIT 1. Turn ignition switch OFF. 2. Check continuity between front power window motor (driver side) harness connector and ground. Is the inspection result normal? YES >> GO TO 7. NO >> GO TO 6. 5. CHECK HARNESS CONTINUITY 1 1. Turn ignition switch OFF. 2. Check continuity between power window main switch harness connector and front power window motor 3. Check continuity between power window main switch harness connector and ground. Is the inspection result normal? YES >> Replace power window main switch. Refer to PWC-112, "Removal and Installation" . NO >> Repair or replace harness. 6. CHECK HARNESS CONTINUITY 2 1. Disconnect power window main switch connector. Power window main switch Ground Continuity Connector Terminal D5 9 Not existed 13 (+) (–) Voltage (V) (Approx.) Front power window motor (driver side) Connector Terminal D7 2 Ground Battery voltage Front power window motor (driver side) Ground Continuity Connector Terminal D7 4 Existed Power window main switch Front power window motor (driver side) Continuity Connector Terminal Connector Terminal D5 15 D7 2 Existed Power window main switch Ground Continuity Connector Terminal D5 15 Not existed |