Nissan Cube. Manual - part 600
INL-20
< SYSTEM DESCRIPTION >
DIAGNOSIS SYSTEM (BCM) (WITHOUT INTELLIGENT KEY SYSTEM)
ACTIVE TEST
BATTERY SAVER
BATTERY SAVER : CONSULT Function (BCM - BATTERY SAVER)
INFOID:0000000009950929
WORK SUPPORT
DATA MONITOR
Monitor item
[Unit]
Description
IGN ON SW
[On/Off]
Indicated [On/Off] condition of ignition switch in ON position
ACC ON SW
[On/Off]
Indicated [On/Off] condition of ignition switch in ACC position
KEY ON SW
[On/Off]
Indicated [On/Off] condition of key switch
DOOR SW-DR
[On/Off]
Indicated [On/Off] condition of front door switch (driver side)
DOOR SW-AS
[On/Off]
Indicated [On/Off] condition of front door switch (passenger side)
DOOR SW-RR
[On/Off]
Indicated [On/Off] condition of rear door switch RH
DOOR SW- RL
[On/Off]
Indicated [On/Off] condition of rear door switch LH
BACK DOOR SW
[On/Off]
Indicated [On/Off] condition of back door switch
LOCK STATUS
[On/Off]
Indicated [On/Off] condition of driver side door
CDL LOCK SW
[On/Off]
Indicated [On/Off] condition of lock signal from door lock unlock switch
CDL UNLOCK SW
[On/Off]
Indicated [On/Off] condition of unlock signal from door lock unlock switch
KEYLESS LOCK
[On/Off]
Indicates [On/Off] condition of lock signal from keyfob
KEYLESS UNLOCK
[On/Off]
Indicates [On/Off] condition of unlock signal from keyfob
KEY CYL LK-SW
[On/Off]
Indicated [On/Off] condition of lock signal from door key cylinder
KEY CYL UN-SW
[On/Off]
Indicated [On/Off] condition of unlock signal from door key cylinder
TRNK/HAT MNTR
[On/Off]
NOTE:
This item is displayed, but cannot be tested
Test item
Operation
Description
INT LAMP
On
Outputs the interior room lamp control signal.
Off
Stops the interior room lamp control signal.
Service item
Setting item
Setting
ROOM LAMP TIMER SET
MODE 1
30 min.
Sets the interior room lamp battery saver timer operating
time.
NOTE:
The factor setting is 10 minutes. The setting cannot be re-
turned to the factory setting, when the setting is changed
once.
MODE 2
60 min.
MODE 3
15 min.