Nissan Versa Note. Manual - part 426

EXL-88

< SYMPTOM DIAGNOSIS >

EXTERIOR LIGHTING SYSTEM SYMPTOMS

SYMPTOM DIAGNOSIS

EXTERIOR LIGHTING SYSTEM SYMPTOMS

Symptom Table

INFOID:0000000009694075

CAUTION:

Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagno-

sis if any DTC is detected.

Symptom

Possible cause

Inspection item

Headlamp does not 
switch to the high beam.

One side

• Fuse
• Harness between IPDM E/R 

and the front combination lamp

• Front combination lamp

(High beam relay)

• IPDM E/R

Headlamp (HI) circuit
Refer to 

EXL-73

.

Both sides

—

Symptom diagnosis
 "BOTH SIDE HEADLAMPS DO 
NOT SWITCH TO HIGH BEAM"
Refer to 

EXL-90

.

High beam indicator lamp is not turned ON.
(Headlamp switches to the high beam.)

• Combination meter
• BCM

• Combination meter. 

Data monitor "HI-BEAM IND"

• BCM (HEAD LAMP)

Active test "HEADLAMP"

Headlamp does not 
switch to the low beam.

One side

Front combination lamp (low 
beam relay)

—

Both sides

• Combination switch (lighting 

and turn signal switch)

• Harness between the combina-

tion switch (lighting and turn sig-
nal switch) and BCM

• BCM

Combination switch (lighting and 
turn signal switch)
Refer to 

EXL-8, "HEADLAMP SYS-

TEM : System Description"

.

High beam request signal
• BCM
• IPDM E/R

IPDM E/R
Data monitor "HL HI REQ"

IPDM E/R

—

Headlamp does not turn 
ON.

One side

• Bulb
• Harness between IPDM E/R 

and the front combination lamp

• Front combination lamp
• IPDM E/R

Headlamp (LO) circuit
Refer to 

EXL-76

.

Both sides

—

Symptom diagnosis
"BOTH SIDE HEADLAMPS (LO) 
ARE NOT TURNED ON"
Refer to 

EXL-91

.

Headlamp does not turn 
OFF.

When the ignition 
switch is turned ON

• BCM
• Combination switch (lighting 

and turn signal switch)

Combination switch (lighting and 
turn signal switch)
Refer to 

EXL-8, "HEADLAMP SYS-

TEM : System Description"

.

Daytime light system does not activate.

• Either high beam bulb
• Parking brake switch
• Combination switch (lighting 

and turn signal switch)

• BCM
• IPDM E/R
• Daytime light relays
• Harness between IPDM E/R 

and daytime light relays.

Daytime light system description.
Refer to 

EXL-9

.

EXTERIOR LIGHTING SYSTEM SYMPTOMS

EXL-89

< SYMPTOM DIAGNOSIS >

C

D

E

F

G

H

I

J

K

M

A

B

EXL

N

O

P

Front fog lamp is not 
turned ON.

One side

• Front fog lamp bulb
• Harness between  the front fog 

lamp and ground 

Front fog lamp circuit
Refer to 

EXL-85

.

Both sides

—

Symptom diagnosis
"BOTH SIDE FRONT FOG LAMPS 
ARE NOT TURNED ON"
Refer to 

EXL-93

.

Parking lamp is not 
turned ON.

One side

• Fuse
• Parking lamp bulb
• Harness between IPDM E/R 

and the front/rear combination 
lamp

• Front/rear combination lamp
• IPDM E/R

Parking lamp circuit
Refer to 

EXL-79

.

Both sides

—

Symptom diagnosis
"PARKING, LICENSE PLATE AND 
TAIL LAMPS ARE NOT TURNED 
ON"
Refer to 

EXL-92

.

Turn signal lamp does 
not blink.

Indicator lamp is nor-
mal.
(The applicable side 
performs the high 
flasher activation).

• Harness between BCM and 

each turn signal lamp

• Turn signal lamp bulb

Turn signal lamp circuit
Refer to 

EXL-82

.

Turn signal indicator 
lamp does not blink.

One side

Combination meter

—

Both sides
(Always)

• Turn signal indicator lamp sig-

nal

• Combination meter
• BCM

• Combination meter. 

Data monitor "TURN IND"

• BCM (FLASHER)

Active test "FLASHER"

Both sides
(Does blink when acti-
vating the hazard 
warning lamp with the 
ignition switch OFF)

• The combination meter power 

supply and the ground circuit

• Combination meter

Combination meter
Power supply and the ground circuit
Refer to 

MWI-7, "METER SYSTEM 

: System Description"

.

Symptom

Possible cause

Inspection item

EXL-90

< SYMPTOM DIAGNOSIS >

BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM

BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM

Description

INFOID:0000000009694076

The headlamps (both sides) do not switch to high beam when the combination switch (lighting and turn signal

switch) is in the HI or PASS setting.

Diagnosis Procedure

INFOID:0000000009694077

1.

COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION

Check the combination switch (lighting and turn signal switch). Refer to 

EXL-88, "Symptom Table"

.

Is the combination switch (lighting and turn signal switch) normal?

YES

>> GO TO 2.

NO

>> Repair or replace the malfunctioning part.

2.

CHECK HEADLAMP (HI) REQUEST SIGNAL INPUT

CONSULT DATA MONITOR

1. Select HL HI REQ of IPDM E/R DATA MONITOR item.

2. While operating the combination switch (lighting and turn signal switch), check the monitor status.

Is the item status normal?

YES

>> GO TO 3.

NO

>> Replace BCM. Refer to 

BCS-70, "Removal and Installation"

 (with Intelligent Key) or 

BCS-127,

"Removal and Installation"

 (without Intelligent Key).

3.

HEADLAMP (HI) CIRCUIT INSPECTION

Check the headlamp (HI) circuit. Refer to 

EXL-8, "HEADLAMP SYSTEM : System Description"

.

Is the headlamp (HI) circuit normal?

YES

>> Replace IPDM E/R. Refer to 

PCS-31, "Removal and Installation"

 (with Intelligent Key) or 

PCS-60,

"Removal and Installation"

 (without Intelligent Key).

NO

>> Repair or replace the malfunctioning part.

Monitor item

Condition

Monitor status

HL HI REQ

Combination switch (lighting and turn signal switch)

HI or PASS

ON

Except for HI or PASS

OFF

BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON

EXL-91

< SYMPTOM DIAGNOSIS >

C

D

E

F

G

H

I

J

K

M

A

B

EXL

N

O

P

BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON

Description

INFOID:0000000009694078

The headlamps (both sides) do not turn ON in any combination switch (lighting and turn signal switch) setting.

Diagnosis Procedure

INFOID:0000000009694079

1.

COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION

Check the combination switch (lighting and turn signal switch). Refer to 

EXL-88, "Symptom Table"

.

Is the combination switch (lighting and turn signal switch) normal?

YES

>> GO TO 2.

NO

>> Repair or replace the malfunctioning part.

2.

CHECK HEADLAMP (LO) REQUEST SIGNAL INPUT

CONSULT DATA MONITOR

1. Select HL LO REQ of IPDM E/R DATA MONITOR item.

2. While operating the combination switch (lighting and turn signal switch), check the monitor status.

Is the item status normal?

YES

>> GO TO 3.

NO

>> Replace BCM. Refer to 

BCS-70, "Removal and Installation"

 (with Intelligent Key) or 

BCS-127,

"Removal and Installation"

 (without Intelligent Key).

3.

HEADLAMP (LO) CIRCUIT INSPECTION

Check the headlamp (LO) circuit. Refer to 

EXL-8, "HEADLAMP SYSTEM : System Description"

.

Is the headlamp (LO) circuit normal?

YES

>> Replace IPDM E/R. Refer to 

PCS-31, "Removal and Installation"

 (with Intelligent Key) or 

PCS-60,

"Removal and Installation"

 (without Intelligent Key).

NO

>> Repair or replace the malfunctioning part.

Monitor item

Condition

Monitor status

HL LO REQ

Combination switch (lighting and turn signal switch)

2ND

ON

OFF

OFF