Nissan Versa Note. Manual - part 141

BRM-16

< REMOVAL AND INSTALLATION >

CORROSION PROTECTION

the new parts. Select an excellent anti-corrosive wax which will penetrate after application and has a long shelf

life.

Undercoating

INFOID:0000000009345080

The underside of the floor and wheelhouse are undercoated to prevent rust, vibration, noise and stone chip-

ping. Therefore, when such a panel is replaced or repaired, apply undercoating to that part. Use an undercoat-

ing which is rust preventive, soundproof, vibration-proof, shock-resistant, adhesive, and durable.

Precautions in Undercoating

1. Do not apply undercoating to any place unless specified (such as the areas above the muffler and three

way catalyst which are subjected to heat).

2. Do not undercoat the exhaust pipe or other parts which become hot.
3. Do not undercoat rotating parts.
4. Apply bitumen wax after applying undercoating.

 Indicates anti-corrosive wax coated portions

Front

AWKIA2529ZZ

CORROSION PROTECTION

BRM-17

< REMOVAL AND INSTALLATION >

C

D

E

F

G

H

I

J

L

M

A

B

BRM

N

O

P

5. After putting seal on the vehicle, put undercoating on it.

 Indicates anti-corrosive wax coated portions

AWKIA2530ZZ

BRM-18

< REMOVAL AND INSTALLATION >

BODY SEALING

BODY SEALING

Description

INFOID:0000000009345081

The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these

areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of

sealant and not to allow other unaffected parts to come into contact with the sealant.

AWKIA2531ZZ

BODY SEALING

BRM-19

< REMOVAL AND INSTALLATION >

C

D

E

F

G

H

I

J

L

M

A

B

BRM

N

O

P

AWKIA2533ZZ

Front