|
|
DLK-334 < DTC/CIRCUIT DIAGNOSIS > [WITHOUT INTELLIGENT KEY SYSTEM] DOOR LOCK AND UNLOCK SWITCH Is the inspection result normal? YES >> Door lock and unlock switch is OK. NO >> Refer to DLK-334, "PASSENGER SIDE : Diagnosis Procedure" PASSENGER SIDE : Diagnosis Procedure INFOID:0000000011279103 Regarding Wiring Diagram information, refer to . 1. CHECK POWER WINDOW SWITCH OUTPUT SIGNAL 1. Turn ignition switch ON. 2. Check voltage at the power window and door lock/unlock switch RH connector when the switch is changed to “LOCK” or “UNLOCK”. Is the inspection result normal? YES >> GO TO 5. NO >> GO TO 2. 2. CHECK POWER WINDOW SWITCH GROUND 1. Turn ignition switch OFF. 2. Disconnect power window and door lock/unlock switch RH connector. 3. Check continuity between power window and door lock/unlock switch RH connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace harness. 3. CHECK POWER WINDOW SWITCH Check continuity between power window and door lock/unlock switch RH terminals. Is the inspection result normal? YES >> GO TO 4. NO >> Replace power window and door lock/unlock switch RH. Refer to PWC-66, "Removal and Installa- . 4. CHECK POWER WINDOW SWITCH CIRCUITS 1. Disconnect BCM connector. CDL UNLOCK SW LOCK : OFF UNLOCK : ON Monitor item Condition Connector Power window and door lock/unlock switch RH state Terminal Voltage (Approx.) D112 Neutral → Lock 1 Ground Battery voltage → 0 Neutral → Unlock 2 Power window and door lock/unlock switch RH con- nector Terminal Continuity D112 3 Ground Yes Power window and door lock/unlock switch RH state Terminals Continuity Lock 1 - 3 Yes Unlock 2 - 3 Neutral/Unlock 1 - 3 No Neutral/Lock 2 - 3 2015 Rogue NAM |