|
|
Content .. 1195 1196 1197 1198 ..
TM-160 < DTC/CIRCUIT DIAGNOSIS > [CVT: RE0F10D] P0965 PRESSURE CONTROL SOLENOID B P0965 PRESSURE CONTROL SOLENOID B DTC Description INFOID:0000000011279381 DTC DETECTION LOGIC POSSIBLE CAUSE • Harness or connector (Primary pressure solenoid valve circuit is open or shorted) • Primary pressure solenoid valve FAIL-SAFE • When a malfunction occurs on the low oil pressure side - Selector shock is large - Start is slow - Acceleration is slow - Lock-up is not performed • When a malfunction occurs on the high oil pressure side - Selector shock is large - Lock-up is not performed DTC CONFIRMATION PROCEDURE 1. PREPARATION BEFORE WORK DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0965 PC SOLENOID B When any of 1 or 2 is satisfied and this state is maintained for 10 sec- When all of the following conditions are satisfied: - DTC other than the applicable DTC is not detected. - Engine speed: More than 625 rpm - Selector lever: Other than P/N position - CVT fluid temperature: More than -20 °C (-4°F) - TCM power supply: More than 11 V - The difference between instruction pressure of primary pressure - Instruction pressure of primary pressure: 0.86 MPa or more - Instruction pressure of primary pressure - primary pressure: More - When all of the following conditions are satisfied and this state is • DTC other than the applicable DTC is not detected. • CVT fluid temperature: More than -20 °C (-4°F) • Selector lever: Other than P/N position • Engine speed: More than 625 rpm • Instruction pressure of primary pressure: More than 2 MPa • Primary pressure: 0.4 MPa or less 2. When all of the following conditions are satisfied: - DTC other than the applicable DTC is not detected. - CVT fluid temperature: More than -20 °C (-4°F) - Selector lever: Other than P/N position - TCM power supply: More than 11 V - When all of the following conditions are satisfied and this state is • DTC other than the applicable DTC is not detected. • CVT fluid temperature: More than -20 °C (-4°F) • Selector lever: Other than P/N position • Primary pressure - instruction pressure of primary pressure: 1.2 - The difference between instruction pressure of primary pressure - Primary pressure - instruction pressure of primary pressure: More |