Nissan Rogue. Manual - part 1137

SRC-98

< SYMPTOM DIAGNOSIS >

SRS AIR BAG WARNING LAMP DOES NOT TURN ON

SYMPTOM DIAGNOSIS

SRS AIR BAG WARNING LAMP DOES NOT TURN ON

AIR BAG Warning Lamp Does Not Turn On

INFOID:0000000011279605

1.

CHECK METER FUSE

Check the 10A fuse [No. 13, located in the fuse block (J/B)].
Is the fuse blown?

YES

>> GO TO 2.

NO

>> GO TO 3.

2.

REPLACE METER FUSE AND CHECK AGAIN

Replace 10A fuse [No. 13, located in the fuse block (J/B)] and turn ignition switch ON.
Does the fuse blow again?

YES

>> Replace fuse and harness.

NO

>> Inspection End.

3.

CHECK HARNESS CONNECTIONS BETWEEN AIR BAG DIAGNOSIS SENSOR UNIT AND COMBINA-

TION METER
Inspect the harness and connectors between the air bag diagnosis sensor unit and the combination meter.
Do the harness or connectors have any visible damage?

YES

>> Replace harness.

NO

>> GO TO 4.

4.

CHECK COMBINATION METER

Disconnect the air bag diagnosis sensor unit harness connectors and turn ignition switch ON.
Does AIR BAG warning lamp turn on?

YES

>> Replace the air bag diagnosis sensor unit. Refer to 

SR-26, "Removal and Installation"

.

NO

>> Replace the combination meter. Refer to 

MWI-84, "Removal and Installation"

.

SRS AIR BAG WARNING LAMP DOES NOT TURN OFF

SRC-99

< SYMPTOM DIAGNOSIS >

C

D

E

F

G

I

J

K

L

M

A

B

SRC

N

O

P

SRS AIR BAG WARNING LAMP DOES NOT TURN OFF

AIR BAG Warning Lamp Does Not Turn Off

INFOID:0000000011279606

1.

CHECK CONDITION OF AIR BAG MODULE

Inspect for any deployed air bag modules or seat belt pre-tensioners.
Are any air bag modules or seat belt pre-tensioners deployed?

YES

>> Refer to Frontal collision: 

SR-5, "FOR FRONTAL COLLISION : When SRS is activated in a colli-

sion"

, 

SR-6, "FOR FRONTAL COLLISION : When SRS is not activated in a collision"

 or Side and

rollover collision: 

SR-7, "FOR SIDE AND ROLLOVER COLLISION : When SRS is activated in a

collision"

, 

SR-9, "FOR SIDE AND ROLLOVER COLLISION : When SRS is not activated in a colli-

sion"

.

NO

>> GO TO 2.

2.

CHECK THE AIR BAG FUSE

Check 10A fuse [No. 32, located in the fuse block (J/B)].
Is the fuse blown?

YES

>> GO TO 3.

NO

>> GO TO 4.

3.

CHECK AIR BAG FUSE AGAIN

Replace 10A fuse [No. 32, located in the fuse block (J/B)] and turn ignition switch ON.
Does the fuse blow again?

YES

>> Replace fuse and harness.

NO

>> Inspection End.

4.

CHECK AIR BAG DIAGNOSIS SENSOR UNIT

Connect CONSULT.
Is “AIR BAG” displayed on CONSULT?

YES

>> GO TO 5.

NO

>> Visually inspect the air bag diagnosis sensor unit harness connections. If the connections are OK,

replace the air bag diagnosis sensor unit. Refer to 

SR-26, "Removal and Installation"

.

5.

CHECK HARNESS CONNECTION

Check for loose connections between the combination meter and the air bag diagnosis sensor unit.
Are there any loose connections?

YES

>> Properly connect the combination meter and air bag diagnosis sensor unit harness connectors. If

AIR BAG warning lamp still does not turn off, replace the wiring harness.

NO

>> Replace air bag diagnosis sensor unit. Refer to 

SR-26, "Removal and Installation"

.

SRC-100

< SYMPTOM DIAGNOSIS >

SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM

Seat Belt Warning System Does Not Function

INFOID:0000000011279607

1.

SEAT BELT WARNING LIGHT

Turn ignition switch ON.
Does the seat belt warning lamp come ON?

YES

>> GO TO 2.

NO

>> • Check 10A fuse [No. 13, located in the fuse block (J/B)].

• Check seat belt buckle switch (driver seat).

• Check harness between combination meter and seat belt buckle switch (driver seat).

• Check combination meter. Refer to 

MWI-30, "Fail-safe"

.

2.

SEAT BELT BUCKLE (DRIVER SEAT)

Fasten the seat belt buckle (driver seat).
Does the seat belt warning lamp go OFF?

YES

>> GO TO 3.

NO

>> • Check seat belt buckle switch (driver seat).

• Check harness between combination meter and seat belt buckle switch (driver seat).

3.

OCCUPANT CLASSIFICATION SYSTEM

Have a helper sit in the passenger seat.
Does the seat belt warning lamp go ON?

YES

>> GO TO 4.

NO

>> • Check occupant classification system. Refer to 

SRC-11, "OCCUPANT CLASSIFICATION SYS-

TEM : System Description"

.

• Check harness between occupant classification control unit and air bag diagnosis sensor unit.

4.

SEAT BELT BUCKLE (PASSENGER SEAT)

Fasten the seat belt buckle (passenger seat).
Does the seat belt warning lamp go OFF?

YES

>> System OK.

NO

>> • Check seat belt buckle switch (passenger seat).

• Check harness between seat belt buckle switch (passenger seat) and air bag diagnosis sensor

unit.

• Replace air bag diagnosis sensor unit. Refer to 

SR-26, "Removal and Installation"

.

ST-1

STEERING

C

D

E

F

H

I

J

K

L

M

SECTION 

ST

A

B

ST

N

O

P

CONTENTS

STEERING SYSTEM

PRECAUTION ...............................................

2

PRECAUTIONS ...................................................

2

Precaution for Supplemental Restraint System 
(SRS) "AIR BAG" and "SEAT BELT PRE-TEN-
SIONER" ...................................................................

2

Service Notice or Precautions for Steering System 

......

2

PREPARATION ............................................

3

PREPARATION ...................................................

3

Special Service Tools ................................................

3

Commercial Service Tools  ........................................

3

SYMPTOM DIAGNOSIS  ...............................

5

NOISE, VIBRATION AND HARSHNESS 
(NVH) TROUBLESHOOTING  .............................

5

NVH Troubleshooting Chart  ......................................

5

BASIC INSPECTION  ....................................

6

STEERING WHEEL .............................................

6

Inspection ..................................................................

6

STEERING COLUMN ..........................................

8

Inspection ..................................................................

8

STEERING GEAR AND LINKAGE  .....................

9

Inspection ..................................................................

9

REMOVAL AND INSTALLATION ...............

11

STEERING WHEEL  ..........................................

11

Exploded View .........................................................

11

Removal and Installation  .........................................

11

STEERING COLUMN ........................................

12

Exploded View .........................................................

12

Removal and Installation  .........................................

12

Inspection ................................................................

13

STEERING GEAR AND LINKAGE  ...................

14

Exploded View .........................................................

14

Removal and Installation  .........................................

14

Inspection ................................................................

15

UNIT DISASSEMBLY AND ASSEMBLY  ....

16

STEERING GEAR AND LINKAGE  ...................

16

Exploded View .........................................................

16

Disassembly and Assembly .....................................

16

SERVICE DATA AND SPECIFICATIONS 
(SDS) ............................................................

18

SERVICE DATA AND SPECIFICATIONS 
(SDS) .................................................................

18

Steering Wheel  ........................................................

18

Steering Angle  .........................................................

18

Steering Column ......................................................

18

Steering Gear  ..........................................................

19