|
|
BCS-46 < ECU DIAGNOSIS INFORMATION > [WITH INTELLIGENT KEY SYSTEM] BCM Fail Safe INFOID:0000000011280203 DTC Inspection Priority Chart INFOID:0000000011280204 If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart. 172 (G) Ground Front door lock assembly Output Main power Unlock (actuator acti- Battery voltage Lock (actuator not ac- 0V 175 (R) Ground Power door lock2 battery Input Push-button OFF Battery voltage 176 (LG) Ground Rear wiper battery power Input Push-button OFF Battery voltage Terminal No. (Wire color) Description Condition Value (Approx.) Signal name Input/ Output (+) (-) CONSULT Display Fail-safe Cancellation B2190: NATS ANTENNA AMP Inhibit engine cranking Erase DTC B2191: DIFFERENCE OF KEY Inhibit engine cranking Erase DTC B2192: ID DISCORD BCM-ECM Inhibit engine cranking Erase DTC B2193: CHAIN OF BCM-ECM Inhibit engine cranking Erase DTC B2198: IMMOBI ANT NG Inhibit engine cranking Erase DTC B2608: STARTER RELAY Inhibit engine cranking 500 ms after the following signal communication status becomes B260F: ECM CAN COMM Inhibit engine cranking When any of the following conditions are fulfilled: B26F1: IGNITION RELAY OFF Inhibit engine cranking When the following conditions are fulfilled: ON B26F2: IGNITION RELAY ON Inhibit engine cranking When the following conditions are fulfilled: OFF B261E: FUEL MIS CONFIG Inhibit engine cranking BCM initialization Priority DTC 1 • B2562: LOW VOLTAGE 2 • U1000: CAN COMM CIRCUIT 3 • B2190: NATS ANTENNA AMP |