|
|
DOOR LOCK FUNCTION DLK-21 < FUNCTION DIAGNOSIS > C D E F G H I J L M A B DLK N O P OPERATION DESCRIPTION/DOOR LOCK/UNLOCK FUNCTION • When door lock/unlock button of the Intelligent Key is pressed, lock signal or unlock signal is transmitted from Intelligent Key to BCM via remote keyless entry receiver. • When BCM receives the door lock/unlock signal, it operates door lock actuator, flashes the hazard lamp (lock: 2 time, unlock: 1 times) and horn chirp signal to IPDM E/R at the same time as a reminder. • IPDM E/R honks horn (lock: 1 time) as a reminder OPERATION CONDITION OPERATION AREA • Operating Range • To ensure the Intelligent Key works effectively, use within 80 cm range of each doors, however the operable range may differ according to surroundings The remote control operation range is greater than that of the Intelligent Key. Refer to Owner’s Manual for more details. SELECTIVE UNLOCK FUNCTION When a LOCK signal is transmitted from Intelligent Key, all doors will be locked. When an UNLOCK signal is transmitted from Intelligent Key once, driver's door will be unlocked. Then, if an UNLOCK signal is transmitted from Intelligent Key again within 5 seconds, all other doors will be unlocked. HAZARD AND HORN REMINDER FUNCTION When doors are locked or unlocked by Intelligent Key, BCM flashes hazard warning lamps as a reminder and sends horn chirp signal to IPDM E/R. IPDM E/R sounds horn as a reminder. The hazard and horn reminder has a horn chirp mode (C mode) and a non-horn chirp mode (S mode). Operating function of hazard and horn reminder Hazard and horn reminder does not operate if any door switch is ON (any door is OPEN). How to change hazard and horn reminder mode With CONSULT-III DLK-52, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY)" . Without CONSULT-III Refer to Owner's Manual for instructions. AUTO DOOR LOCK FUNCTION Auto Door Lock Function When all doors are locked, ignition switch is OFF (ignition switch is not pressed) and key switch is OFF (Intel- ligent Key is not inserted in key slot), doors are unlocked with Intelligent Key button. When BCM does not receive the following signals within 60 seconds, all doors are locked. • Door switch is ON (door is opened) • Door is locked • Ignition switch is ON • Key switch is ON (Intelligent Key is inserted in key slot) Auto door lock mode can be changed by DOOR LOCK-UNLOCK SET mode in “WORK SUPPORT”. Refer to DLK-52, "DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK)" . PANIC ALARM FUNCTION When ignition switch is OFF (ignition switch is not pressed) and key switch is OFF (Intelligent Key is not inserted in key slot), BCM receives PANIC ALARM signal from Intelligent Key. BCM turns on and off headlamp intermittently and transmits theft warning horn signal to IPDM E/R. Then, IPDM E/R turns on and off horn intermittently. The headlamp flashes and the horn sounds intermittently. Remote controller operation Operation condition Operation Lock • All doors closed All doors lock Unlock • Intelligent Key is out of key slot All doors unlock C mode S mode Intelligent Key operation Lock Unlock Trunk open Lock Unlock Trunk open Hazard warning lamp flash Twice Once — Twice — — Horns sound Once — — — — — |