Nissan Leaf. Manual - part 584

 

  Index      Nissan     Nissan Leaf (2011-2014 year) - Service and Repair Manual

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  582  583  584  585   ..

 

 

Nissan Leaf. Manual - part 584

 

 

EVC-360

< DTC/CIRCUIT DIAGNOSIS >

P31EC WATER PUMP

P31EC WATER PUMP

DTC Logic

INFOID:0000000010120822

DTC DETECTION LOGIC

NOTE:

This DTC may be detected where there is the mixing of air into coolant. 

DTC CONFIRMATION PROCEDURE

1.

PRECONDITIONING

• Turn power switch OFF and wait at least 90 seconds.

CAUTION:

During this period, never perform vehicle handling such as opening and closing of doors. If some

kind of vehicle handling is performed, then wait another 90 seconds or more from the time of the

vehicle handling.

• Make sure that 12V battery voltage is 11 V or more.

>> GO TO 2.

2.

PERFORM DTC CONFIRMATION PROCEDURE

1. Set the vehicle to READY and wait at least 60 seconds.

2. Check DTC.
Is DTC detected?

YES

>> Proceed to 

EVC-360, "Diagnosis Procedure"

.

NO

>> INSPECTION END

Diagnosis Procedure

INFOID:0000000010120823

1.

CHECK DTC

Perform self-diagnosis of VCM.
Is DTC detected other than P31EC?

YES

>> Perform diagnosis procedure of detected DTC Refer to 

EVC-102, "DTC Index"

.

NO

>> GO TO 2.

2.

CHECK WATER PUMP FEEDBACK DUTY

On the CONSULT screen, select “EV/HEV” >> “DATA MONITOR” >> “W/P 1 CRNT SPD DUTY”.
Is value between 3% and 7%?

YES

>> GO TO 3.

NO

>> GO TO 4.

3.

CHECK COOLANT

1. Turn power switch OFF.

2. Check that the coolant is free from air mixture.
Is the inspection result normal?

YES

>> GO TO 4.

NO

>> Perform the air bleeding. Refer to 

HCO-12, "Refilling"

.

4.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

With CONSULT

1. Turn power switch ON and erase DTC.

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detecting condition

Possible cause

P31EC

WATER PUMP 1
(Water pump 1)

Electric water pump feedback duty keeps between 3% and 7% for 
30 seconds.

• Harness or connectors
• Electric water pump
• VCM

P31EC WATER PUMP

EVC-361

< DTC/CIRCUIT DIAGNOSIS >

D

E

F

G

H

I

J

K

L

M

A

B

EVC

N

O

P

2. Perform DTC confirmation procedure again. Refer to 

EVC-360, "DTC Logic"

.

Is DTC “P31EC” detected again?

YES

>> Replace VCM. Refer to 

EVC-423, "Removal and Installation"

.

NO

>> INSPECTION END

EVC-362

< DTC/CIRCUIT DIAGNOSIS >

P31EE REFRIGERANT PRESSURE SENSOR

P31EE REFRIGERANT PRESSURE SENSOR

DTC Logic

INFOID:0000000010120824

DTC DETECTION LOGIC

NOTE:

If DTC P31EE is displayed with DTC P31E5, first perform the trouble diagnosis for DTC P31E5. Refer to

EVC-351, "DTC Logic"

.

DTC CONFIRMATION PROCEDURE

1.

PRECONDITIONING

• Turn power switch OFF and wait at least 90 seconds.

CAUTION:

During this period, never perform vehicle handling such as opening and closing of doors. If some

kind of vehicle handling is performed, then wait another 90 seconds or more from the time of the

vehicle handling.

• Make sure that 12V battery voltage is 11 V or more.

>> GO TO 2.

2.

PERFORM CONFIRMATION PROCEDURE

With CONSULT

1. Turn power switch ON at least 20 seconds.

2. Check self-diagnostic result.
Is DTC detected?

YES

>> Proceed to 

EVC-362, "Diagnosis Procedure"

.

NO

>> INSPECTION END

Diagnosis Procedure

INFOID:0000000010120825

1.

CHECK REFRIGERANT PRESSURE SENSOR POWER SUPPLY-1

1. Turn power switch OFF.

2. Disconnect refrigerant pressure sensor harness connector.

3. Turn power switch ON.

4. Check the voltage between refrigerant pressure sensor harness connector terminals.

Is the inspection result normal?

YES

>> GO TO 7.

NO

>> GO TO 2.

2.

CHECK REFRIGERANT PRESSURE SENSOR POWER SUPPLY-2

Check the voltage between refrigerant pressure sensor harness connector and ground.

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detecting condition

Possible cause

P31EE

REFRIGERANT PRES-
SURE SENSOR
(Refrigerant pressure sen-
sor)

• Signal voltage from refrigerant pressure sensor remains 

Approx. 0 V for 2.5 seconds or more

• Signal voltage from refrigerant pressure sensor remains 

Approx. 4.7 V or more for 2.5 seconds or more

• Harness or connectors

(Refrigerant pressure sensor 
circuit is open or shorted.)

• Refrigerant pressure sensor
• VCM

Refrigerant pressure sensor

Voltage

(Approx.)

Connector

+

Terminal

E49

3

1

5 V

P31EE REFRIGERANT PRESSURE SENSOR

EVC-363

< DTC/CIRCUIT DIAGNOSIS >

D

E

F

G

H

I

J

K

L

M

A

B

EVC

N

O

P

Is the inspection result normal?

YES

>> GO TO 4.

NO

>> GO TO 3.

3.

CHECK REFRIGERANT PRESSURE SENSOR POWER SUPPLY CIRCUIT

1. Turn power switch OFF.

2. Disconnect VCM harness connector.

3. Check the continuity between refrigerant pressure sensor and VCM harness connector.

4. Also check harness for short to ground and short to power.
Is the inspection result normal?

YES

>> Check power supply circuit for sensor power supply. Refer to 

EVC-351, "Diagnosis Procedure"

.

NO

>> Repair or replace error-detected parts.

4.

CHECK REFRIGERANT PRESSURE SENSOR GROUND CIRCUIT

1. Turn power switch OFF.

2. Disconnect VCM harness connector.

3. Check the continuity between refrigerant pressure sensor and VCM harness connector.

Is the inspection result normal?

YES

>> GO TO 5.

NO

>> Repair or replace error-detected parts.

5.

CHECK VCM GROUND CIRCUIT

Check the continuity between VCM harness connector and ground.

Is the inspection result normal?

YES

>> GO TO 6.

NO

>> Repair or replace error-detected parts.

6.

CHECK INTERMITTENT INCIDENT

+

Voltage

(Approx.)

Refrigerant pressure sensor

Connector

Terminal

E49

3

Ground

5 V

+

Continuity

Refrigerant pressure sensor

VCM

Connector

Terminal

Connector

Terminal

E49

3

E62

98

Existed

+

Continuity

Refrigerant pressure sensor

VCM

Connector

Terminal

Connector

Terminal

E49

1

E62

123

Existed

+

Continuity

VCM

Connector

Terminal

E61

58

Ground

Existed

65

E62

118

126

 

 

 

 

 

 

 

Content   ..  582  583  584  585   ..