Nissan March K13. Manual - part 470

MWI-18

< SYSTEM DESCRIPTION >

DIAGNOSIS SYSTEM (COMBINATION METER)

NOTE:
• If any of the meters or gauges is not activated, replace combination meter.
• The figure is reference.

CONSULT-III Function

INFOID:0000000005883870

APPLICATION ITEMS

CONSULT-III can perform the following diagnosis modes via CAN communication and the combination meter.

SELF DIAG RESULT

Refer to 

MWI-27, "DTC Index"

.

DATA MONITOR

Display Item List

X: Applicable

System

Diagnosis mode

Description

METER/M&A

Self Diagnostic Result

The combination meter checks the conditions and displays memorized errors.

Data Monitor

Displays the combination meter input/output data in real time.

Special function

Lighting history of the warning lamp and indicator lamp can be checked.

Display item [Unit]

MAIN

SIGNALS

Description

SPEED METER
[km/h]

X

• Value of vehicle speed signal received from ABS actuator and electric unit (con-

trol unit) via CAN communication. (Models with ABS)
NOTE:
655.35 is displayed when the malfunction signal is received.

• Value of vehicle speed signal received from TCM via CAN communication. (A/

T models without ABS)
NOTE:
655.35 is displayed when the malfunction signal is received.

• Value of vehicle speed sensor signal received from vehicle speed sensor. (M/T 

models)

SPEED OUTPUT
[km/h]

X

Vehicle speed signal value transmitted to other units via CAN communication.
NOTE:
655.35 is displayed when the malfunction signal is received.

ODO OUTPUT
[km/h or mph]

Odometer signal value transmitted to other units via CAN communication.

TACHO METER
[rpm]

X

Value of the engine speed signal received from ECM via CAN communication.
NOTE:
8191.875 is displayed when the malfunction signal is received.

FUEL METER
[L]

X

Fuel level indicated on combination meter.

W TEMP METER
[

°

C] 

X

Value of engine coolant temperature signal is received from ECM via CAN com-
munication.
NOTE:
215 is displayed when the malfunction signal is input.

ABS W/L
[On/Off]

Status of ABS warning lamp detected from ABS warning lamp signal is received 
from ABS actuator and electric unit (control unit) via CAN communication.

BRAKE W/L
[On/Off]

Status of brake warning lamp detected from brake warning lamp signal is received 
from ABS actuator and electric unit (control unit) via CAN communication.
NOTE:
Displays “Off” if the brake warning lamp is illuminated when the valve check starts, 
the parking brake switch is turned ON or the brake fluid level switch is turned ON.

DOOR W/L
[On/Off]

Status of door warning detected from door switch signal received from BCM via 
CAN communication.

HI-BEAM IND
[On/Off]

Status of high beam indicator lamp detected from high beam request signal is re-
ceived from BCM via CAN communication.

MWI

DIAGNOSIS SYSTEM (COMBINATION METER)

MWI-19

< SYSTEM DESCRIPTION >

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

TURN IND
[On/Off]

Status of turn indicator lamp detected from turn indicator signal is received from 
BCM via CAN communication.

FR FOG IND
[On/Off]

Status of front fog lamp indicator lamp detected from front fog light request signal 
is received from BCM via CAN communication.

OIL W/L
[On/Off]

Status of oil pressure warning lamp detected from oil pressure switch signal is re-
ceived from BCM via CAN communication.

MIL
[On/Off] 

Status of malfunction indicator lamp detected from malfunctioning indicator lamp 
signal is received from ECM via CAN communication.

GLOW IND
[Off]

This item is displayed, but cannot be monitored.

C-ENG2 W/L
[Off]

This item is displayed, but cannot be monitored.

CRUISE IND
[Off]

This item is displayed, but cannot be monitored.

SET IND
[Off]

This item is displayed, but cannot be monitored.

O/D OFF IND
[On/Off]

Status of OD OFF indicator lamp detected from OD OFF indicator lamp signal is 
received from TCM via CAN communication.

FUEL W/L
[On/Off]

Low-fuel warning status detected by the identified fuel level.

KEY G/Y W/L
[On/Off]

Status of KEY warning lamp (Green/Yellow) detected from KEY warning lamp sig-
nal is received from BCM via CAN communication.

EPS W/L
[On/Off]

Status of EPS warning lamp detected from EPS warning lamp signal is received 
from EPS control unit via CAN communication. 

e-4WD W/L
[Off]

This item is displayed, but cannot be monitored.

DPF W/L
[Off]

This item is displayed, but cannot be monitored.

FILTER W/L
[Off]

This item is displayed, but cannot be monitored.

LCD
[B&P N, B&P I, SFT P, NO KY]

Status of engine start operation indicator, shift P warning lamp and KEY warning 
lamp, detected from engine start operation indicator signal, shift P warning lamp 
signal and KEY warning lamp signal are received from BCM via CAN communi-
cation.

SHIFT IND
[P, R, N, D, 2, 1]

Status of shift position, detected from shift position signal received from TCM via 
CAN communication.

O/D OFF SW
[On/Off]

Status of over drive control switch.

COMP F/B SIG
[On/Off]

A/C compressor activation condition that ECM judges according to the engine 
coolant temperature and the acceleration degree.

PKB SW
[On/Off]

Status of parking brake switch.

BUCKLE SW
[On/Off]

This item is displayed, but cannot be monitored.

BRAKE SW
[On/Off]

This item is displayed, but cannot be monitored.

BRAKE OIL SW
[On/Off]

Status of brake fluid level switch.

DISTANCE
[km]

Value of possible driving distance calculated by combination meter.

Display item [Unit]

MAIN

SIGNALS

Description

MWI-20

< SYSTEM DESCRIPTION >

DIAGNOSIS SYSTEM (COMBINATION METER)

NOTE:

Some items are not available according to vehicle specification.

SPECIAL FUNCTION

Special menu

W/L ON HISTORY

• Stores histories when warning/indicator lamp is turned on.
• “W/L ON HISTORY” indicates the “TIME” when the warning/ indicator lamp is turned on.
• The “TIME” above is:
- 0: The condition that the warning/indicator lamp has been turned on 1 or more times after starting the engine

and waiting for 30 seconds.

- 1 - 39: The number of times the engine was restarted after the 0 condition.
- NO W/L ON HISTORY: Stores NO (0) turning on history of warning/indicator lamp.
NOTE:
• W/L ON HISTORY is not stored for approximately 30 seconds after the engine starts.
• Brake warning lamp does not store any history when the parking brake is applied or the brake fluid level gets

low.

Display Item

FUEL LOW SIG
[On/Off]

Status of fuel level low warning signal to output to AV control unit via CAN com-
munication.

BUZZER
[On/Off]

X

Buzzer status (in the combination meter) is detected from the buzzer output signal 
received from each unit via CAN communication and the warning output condition 
of the combination meter.

Display item [Unit]

MAIN

SIGNALS

Description

Display item

Description

W/L ON HISTORY

Lighting history of warning lamp and indicator lamp can be checked.

Display item

Description

ABS W/L

Lighting history of ABS warning lamp.

VDC/TCS IND

This item is displayed, but cannot be monitored.

SLIP IND

This item is displayed, but cannot be monitored.

BRAKE W/L

Lighting history of brake warning lamp. (With ABS)

DOOR W/L

Lighting history of door warning lamp.

TRUNK/GLAS-H

This item is displayed, but cannot be monitored.

OIL W/L

Lighting history of oil pressure warning lamp.

C-ENG W/L

Lighting history of malfunction indicator lamp.

C-ENG2 W/L

This item is displayed, but cannot be monitored.

CRUISE IND

This item is displayed, but cannot be monitored.

SET IND

This item is displayed, but cannot be monitored.

CRUISE W/L

This item is displayed, but cannot be monitored.

BA W/L

This item is displayed, but cannot be monitored.

O/D OFF IND 

Lighting history of OD OFF indicator lamp.

ATC/T-AMT W/L

This item is displayed, but cannot be monitored.

ATF TEMP W/L

This item is displayed, but cannot be monitored.

CVT IND

This item is displayed, but cannot be monitored.

SPORT IND

This item is displayed, but cannot be monitored.

4WD W/L

This item is displayed, but cannot be monitored.

FUEL W/L

Lighting history of low fuel level warning lamp.

MWI

DIAGNOSIS SYSTEM (COMBINATION METER)

MWI-21

< SYSTEM DESCRIPTION >

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

WASHER W/L

This item is displayed, but cannot be monitored.

AIR PRES W/L

This item is displayed, but cannot be monitored.

KEY G/Y W/L

Lighting history of KEY warning lamp (Green/Yellow).

KEY R W/L

This item is displayed, but cannot be monitored.

KEY KNOB W/L

This item is displayed, but cannot be monitored.

EPS W/L

Lighting history of EPS warning lamp.

e-4WD 

This item is displayed, but cannot be monitored.

AFS OFF IND

This item is displayed, but cannot be monitored.

4WAS/RAS W/L

This item is displayed, but cannot be monitored.

HDC W/L

This item is displayed, but cannot be monitored.

SYS FAIL W/L

This item is displayed, but cannot be monitored.

SFT POSI W/L

This item is displayed, but cannot be monitored.

HV BAT W/L

This item is displayed, but cannot be monitored.

HEV BRAKE W/L

This item is displayed, but cannot be monitored.

SFT OPER W/L

This item is displayed, but cannot be monitored.

LANE W/L

This item is displayed, but cannot be monitored.

CHAGE W/L

This item is displayed, but cannot be monitored.

OIL LEV LOW

This item is displayed, but cannot be monitored.

DPF W/L

This item is displayed, but cannot be monitored.

TRAILER IND

This item is displayed, but cannot be monitored.

RUN FLAT W/L

This item is displayed, but cannot be monitored.

E-SUS W/L

This item is displayed, but cannot be monitored.

LAUNCH CNT W/L

This item is displayed, but cannot be monitored.

BRAKE PAD W/L

This item is displayed, but cannot be monitored.

Display item

Description