|
|
AT-280 [EXC.F/EURO-OBD] TROUBLE DIAGNOSIS — BASIC INSPECTION Cruise Test — Part 2 1. CHECK STARTING GEAR (D 1 ) POSITION 1. Confirm overdrive control switch is in “ON” position. 2. Confirm selector lever is in “D” position. 3. Accelerate vehicle by half throttle again. 4. Does vehicle start from D 1 ? Read gear position. Yes or No Yes >> GO TO 2 No >> ● GO TO AT-334, "16. Vehicle Does Not Start From D . ● Continue ROAD TEST. Refer to . 2. CHECK SHIFT UP AND SHIFT DOWN (D 3 TO D 4 TO D 2 ) 1. Accelerate vehicle to 80 km/h (50 MPH) as shown in illustration. 2. Release accelerator pedal and then quickly depress it fully. 3. Does A/T shift from D 4 to D 2 as soon as accelerator pedal is depressed fully? Read gear position and throttle position. Yes or No Yes >> GO TO 3 No >> ● GO TO AT-324, "9. A/T Does Not Shift: D . ● Continue ROAD TEST. Refer to . 3. CHECK SHIFT UP (D 2 TO D 3 ) Does A/T shift from D 2 to D 3 at the specified speed? Read gear position, throttle position and vehicle speed. Yes or No Yes >> GO TO 4 No >> ● GO TO AT-326, "10. A/T Does Not Shift: D . ● Continue ROAD TEST. Refer to . SAT495G SAT404H Specified speed when shifting from D 2 to D 3 : Refer to . SAT960I |