|
|
PRECAUTIONS SB-3 < PRECAUTION > C D E F G I J K L M A B SB N O P tensioners should be replaced even if the seat belts are not in use during a frontal collision in which les show no damage and continue to operate properly). • The seat belt is damaged in an accident (i.e. torn webbing, bent retractor or guide). distortion and repair as necessary before installing a new seat belt assembly. • Anchor bolts are deformed or worn out. which the air bags are deployed. FOR MEXICO FOR MEXICO : Precaution for Supplemental Restraint System (SRS) "AIR BAG" and INFOID:0000000008455307 The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along WARNING: Always observe the following items for preventing accidental activation. the event of a collision that would result in air bag inflation, all maintenance must be performed by • Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag • Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Ser- vice Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS WARNING: Always observe the following items for preventing accidental activation. ignition ON or engine running, never use air or electric power tools or strike near the sensor(s) with • When using air or electric power tools or hammers, always switch the ignition OFF, disconnect the battery, and wait at least 3 minutes before performing any service. FOR MEXICO : Precaution for Seat Belt Service INFOID:0000000008455308 CAUTION: • Before removing the front seat belt pre-tensioner assembly, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes. • Never use electrical test equipment for front seat belt pre-tensioner connector. pre-tensioner connector, check the system function. Refer to • Never use disassembled buckle or seat belt assembly. assembly. • If webbing is cut, frayed or damaged, replace seat belt assembly. AFTER A COLLISION WARNING: Inspect all seat belt assemblies including retractors and attached hardware after any collision. Revision: 2012 September 2013 MURANO |