|
|
DTC P0715 INPUT SPEED SENSOR CIRCUIT (PRI SPEED SENSOR) CVT-97 D E F G H I J K L M A B CVT Revision: 2006 August 2006 Murano 4. CHECK HARNESS BETWEEN TCM AND CVT UNIT HARNESS CONNECTOR [INPUT SPEED SEN- SOR (PRIMARY SPEED SENSOR)] 1. Turn ignition switch OFF. 2. Disconnect TCM connector and CVT unit harness connector. 3. Check continuity between TCM connector terminal and CVT unit 4. If OK, check harness for short to ground and short to power. 5. Reinstall any part removed. OK or NG OK >> GO TO 5. NG >> Repair open circuit or short to ground or short to power in harness or connectors. 5. CHECK THE TCM SHORT Replace same type TCM, perform self-diagnosis check. Erase self-diagnostic results and then drive the vehi- CVT-93, "DTC Confirmation Procedure" . YES >> Replace the transaxle assembly. Refer to CVT-229, "Removal and Installation" . NO >> Replace TCM. Refer to CVT-9, "Precautions for TCM and CVT Assembly Replacement" . 6. CHECK DTC Perform “DTC Confirmation Procedure”. Refer to CVT-93, "DTC Confirmation Procedure" OK or NG OK >> INSPECTION END NG >> GO TO 7. 7. CHECK TCM 1. Check TCM input/output signals. Refer to CVT-57, "TCM Input/Output Signal Reference Values" . 2. If NG, re-check TCM pin terminals for damage or loose connection with harness connector. OK or NG OK >> INSPECTION END NG >> Repair or replace damaged parts. Item Connector Terminal Continuity TCM connector F104 38 Yes CVT unit harness connector F6 22 SCIA4682E |