|
|
TROUBLE DIAGNOSIS CVT-65 D E F G H I J K L M A B CVT Revision: 2006 August 2006 Murano SELF-DIAGNOSTIC RESULT MODE After performing self-diagnosis, place check marks for results on the CVT-36, "DIAGNOSTIC WORKSHEET" Reference pages are provided following the items. Operation Procedure 1. Touch “SELF-DIAG RESULTS” on “SELECT DIAG MODE” Display Items List X: Applicable —: Not applicable BCIA0031E Items (CONSULT- Malfunction is detected when... TCM self- diagnosis OBD-II (DTC) Reference page “TRANS- MISSION” SULT-II MIL *1, “ENGINE” with CONSULT-II or GST CAN COMM CIR- When TCM is not transmitting or receiving CAN communica- U1000 U1000 STARTER RELAY/ If this signal is ON other than in P or N position, this is P0615 — BRAKE SW/CIRC When the brake switch does not switch to ON or OFF P0703 — PNP SW/CIRC ● PNP switch 1-4 signals input with impossible pattern ● PNP switch 3 monitor terminal open or short circuit P0705 P0705 ATF TEMP SEN/ During running, the CVT fluid temperature sensor signal volt- P0710 P0710 INPUT SPD SEN/ ● Input speed sensor (primary speed sensor) signal is not ● An unexpected signal is input when vehicle is being P0715 P0715 VEH SPD SEN/ ● Signal from vehicle speed sensor CVT [Output speed sen- ● Unexpected signal input during running P0720 P0720 ENGINE SPEED TCM does not receive the CAN communication signal from P0725 — BELT DAMG Unexpected gear ratio detected P0730 — TCC SOLENOID/ Normal voltage not applied to solenoid due to open or short P0740 P0740 A/T TCC S/V ● CVT cannot perform lock-up even if electrical circuit is ● TCM detects as irregular by comparing difference value P0744 P0744 L/PRESS SOL/ ● Normal voltage not applied to solenoid due to open or ● TCM detects as irregular by comparing target value with P0745 P0745 |