Nissan Murano Z50 (2004 year). Manual - part 68
WARNING CHIME
DI-75
C
D
E
F
G
H
I
J
L
M
A
B
DI
Revision: 2004 November
2004 Murano
Seat Belt Warning Chime Does Not Operate
AKS004HD
1.
CHECK WARNING CHIME OPERATION
Check the chime under conditions in exception of seat belt warning chime operation.
Does warning chime sound?
YES
>> GO TO 2.
NO
DI-71, "All Warnings Are Not Operated"
.
2.
CHECK BCM INPUT SIGNAL
1.
Select “BCM” on CONSULT-II.
2.
With “DATA MONITOR” of “BUZZER”, confirm “BUCKLE SW”
when the seat belt buckle switch is operated.
OK or NG
OK
>> Replace BCM. Refer to
BCS-14, "Removal and Installa-
NG
>> GO TO 3.
3.
CHECK COMBINATION METER INPUT SIGNAL
1.
Turn ignition switch ON.
2.
Check voltage between combination meter harness connector
M25 terminal 3 (LG) and ground.
OK or NG
OK
>> Replace combination meter.
NG
>> GO TO 4.
4.
CHECK SEAT BELT BUCKLE SWITCH
1.
Turn ignition switch OFF.
2.
Disconnect seat belt buckle switch (driver side) connector.
3.
Check continuity between seat belt buckle switch (driver side)
harness connector B308 terminals 50 and 65.
OK or NG
OK
>> GO TO 5.
NG
>> Replace seat belt buckle switch (driver side).
When seat belt is fastened
: BUCKLE SW OFF
When seat belt is unfastened
: BUCKLE SW ON
SKIA9201E
When seat belt is fastened
: Approx. 12V
When seat belt is unfastened
: Approx. 0V
PKIA2506E
When seat belt is
fastened
: Continuity should not exist.
When seat belt is
unfastened
: Continuity should exist.
SKIA5574E