Nissan Murano. Manual - part 300

DAS-90

< SYMPTOM DIAGNOSIS >

[LDW]

LDW ON INDICATOR LAMP DOES NOT TURNED ON

LDW ON INDICATOR LAMP DOES NOT TURNED ON

Description

INFOID:0000000009723287

The LDW ON indicator lamp in the combination meter does not turn ON when turning on the ignition switch

Diagnosis Procedure

INFOID:0000000009723288

1.

CHECK COMBINATION METER

Turn the ignition switch from OFF to ON to check that “LDW IND” included in “DATA MONITOR” in “METER/
M&A” operates normally.
Is the inspection result normal?

YES

>> Replace the combination meter. Refer to 

MWI-105, "Removal and Installation"

.

NO

>> GO TO 2.

2.

CHECK SELF-DIAGNOSIS RESULTS OF COMBINATION METER

1.

Perform “All DTC Reading” with CONSULT.

2.

Check if the DTC is detected in self-diagnosis results of “METER/M&A” Refer to 

MWI-77, "DTC Index"

.

Is any DTC detected?

YES

>> Repair or replace malfunctioning parts.

NO

>> GO TO 3.

3.

CHECK SELF-DIAGNOSIS RESULTS OF CAMERA CONTROL UNIT

Check if the DTC is detected in self-diagnosis results of “AVM” Refer to 

DAS-30, "DTC Index"

.

Is any DTC detected?

YES

>> Repair or replace malfunctioning parts.

NO

>> Replace the camera control unit. Refer to 

DAS-94, "Removal and Installation"

.

DAS

THE SYSTEM OPERATES EVEN WHEN USING TURN SIGNAL

DAS-91

< SYMPTOM DIAGNOSIS >

[LDW]

C

D

E

F

G

H

I

J

K

L

M

B

N

P

A

THE SYSTEM OPERATES EVEN WHEN USING TURN SIGNAL

Description

INFOID:0000000009723289

The warning of Lane Departure Warning (LDW) is activated during the use of a turn signal.
NOTE:
For the operational conditions of Lane Departure Warning (LDW), refer to 

DAS-12, "System Description"

.

Diagnosis Procedure

INFOID:0000000009723290

1.

CHECK TURN SIGNAL OPERATION

Check that both right and left turn signals are normal.

Is the inspection result normal?

YES

>> GO TO 2.

NO

>> Repair or replace malfunctioning parts. Refer to 

EXL-162, "Symptom Table"

.

2.

CHECK SELF-DIAGNOSIS RESULTS

1.

Perform “All DTC Reading” with CONSULT.

2.

Check if the DTC is detected in self-diagnosis results of “AVM” Refer to 

DAS-30, "DTC Index"

.

Is any DTC detected?

YES

>> Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts.

NO

>> Replace camera control unit. Refer to 

DAS-94, "Removal and Installation"

.

DAS-92

< SYMPTOM DIAGNOSIS >

[LDW]

SYSTEM SETTINGS CANNOT BE TURNED ON/OFF ON THE NAVIGATION 

SCREEN

SYSTEM SETTINGS CANNOT BE TURNED ON/OFF ON THE NAVIGATION
SCREEN

Description

INFOID:0000000009723291

• LDW system setting is not selectable on the navigation screen.

NOTE:
When the ignition switch is in ACC position, LDW system settings cannot be changed.

- “Lane Departure Warning” is not indicated on the navigation screen.
- The switching between ON and OFF cannot be performed by operating the navigation system.
- The item of “Lane Departure Warning” on the navigation screen is not active.
• After turning ON the ignition switch or starting the engine, LDW settings of the navigation system cannot be

selected for several tens of seconds under the following conditions:

- After replacing AV control unit.
- After erasing connection history of the navigation system.
- After erasing self-diagnosis results of AV control unit.
• The LDW system setting differs from the one set at the previous driving. 

NOTE:
Turn OFF the ignition switch and wait for 5 seconds or more.

Diagnosis Procedure

INFOID:0000000009723292

1.

CHECK LDW SYSTEM SETTING

1.

Start the engine.

2.

Check that the LDW system settings is selectable on the navigation screen.

Is the inspection result normal?

YES

>> GO TO 3.

NO

>> GO TO 2.

2.

PERFORM THE SELF-DIAGNOSIS

1.

Perform self-diagnosis with CONSULT. 

2.

Check if the DTC is detected in self-diagnosis results of “AVM” and “MULTI AV”. Refer to the following.

-

AVM: 

DAS-30, "DTC Index"

-

MULTI AV: 

AV-340, "DTC Index"

Is any DTC detected?

YES

>> Repair or replace malfunctioning parts.

NO

>> INSPECTION END

3.

CHECK MULTIFUNCTION SWITCH

Operate the multifunction switch to check that the audio, navigation system, and air conditioner operate prop-
erly.
Is the inspection result normal?

YES

>> Replace the camera control unit. Refer to 

DAS-94, "Removal and Installation"

.

NO

>> Repair or replace malfunctioning parts.

DAS

NORMAL OPERATING CONDITION

DAS-93

< SYMPTOM DIAGNOSIS >

[LDW]

C

D

E

F

G

H

I

J

K

L

M

B

N

P

A

NORMAL OPERATING CONDITION

Description

INFOID:0000000009723293

PRECAUTIONS FOR LANE DEPARTURE WARNING (LDW)

• The LDW system is only a warning device to inform the driver of a potential unintended lane departure. It will

not steer the vehicle or prevent loss of control. It is the driver

′

s responsibility to stay alert, drive safely, keep

the vehicle in the traveling lane, and be in control of the vehicle at all times.

• The rear view camera may not detect properly under the following conditions:
- When towing a trailer.
- When strong light enters the rear view camera. (For example, direct sunlight or headlight from the rear)
- When ambient brightness changes instantly. (For example, when the vehicle enters or exits a tunnel or

passes under a bridge.)

• Automatic washer and blower may not be able to secure detection capability when excessive dirt adheres on

the camera lens.

• LDW system may not function properly under the following conditions:
• Excessive noise (e.g. audio system volume, open vehicle window) will interfere with the chime sound, and it

may not be heard.

• The rear view camera may not be able to detect properly under the following conditions:
- On roads where there are multiple parallel lane markers; lane markers that are faded or not painted clearly;

yellow painted lane markers; non-standard lane markers; or lane markers covered with water, dirt, snow, etc.

- On roads where the discontinued lane markers are still detectable.
- On roads where there are sharply contrasting objects, such as shadows, snow, water, wheel ruts, seams or

lines remaining after road repairs. (The LDW system could detect these items as lane markers.)

- On roads where the traveling lane merges or separates.
- When the vehicle

′

s traveling direction does not align with the lane marker.

- When the road surface is very dark due to scarce ambient light or impaired tail lamp.
• When driving on curved road, warning will be late on the outside of the curve due to the nature of the sys-

tem.