Nissan Primera P12. Manual

LT-4

PRECAUTION

PFP:00011

Precautions for Supplemental Restraint System (SRS) “AIR BAG” and “SEAT
BELT PRE-TENSIONER”

EKS009LJ

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the SRS and SB section of
this Service Manual.

WARNING:

●

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.

●

Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.

●

Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.

Precaution

EKS009LK

●

Do not touch the glass of bulb directly by hand. Keep grease and other oily matters away from it. Do not
touch bulb by hand while it is lit or right after being turned off. Burning may result.

●

Do not leave bulb out of headlamp reflector for a long time because dust, moisture smoke, etc. may affect
the performance of the headlamp. When replacing the bulb, be sure to replace it with a new one.

●

Adjust aiming by tightening aiming screw. (To adjust it toward loosening side, first loosen adjusting screw,
and then make adjustment by tightening.)

●

To remove soil or sealant of bulbs, do not use organic solvent (thinner, gasoline, etc.)

●

When replacing bulb, be sure to hold bulb socket and pull it out straight. If wiring harness of the bulb is
pulled at an angle, the bulb may be caught in the lamp, making it difficult to take out.

Wiring Diagrams and Trouble Diagnosis

EKS009LL

When you read wiring diagrams, refer to the following:

●

GI-14, "How to Read Wiring Diagrams"

in GI section

●

PG-3, "POWER SUPPLY ROUTING"

for power distribution circuit in PG section

When you perform trouble diagnosis, refer to the following:

●

GI-11, "HOW TO FOLLOW TEST GROUPS IN TROUBLE DIAGNOSES"

in GI section

●

GI-24, "How to Perform Efficient Diagnosis for an Electrical Incident"

in GI section

HEADLAMP -CONVENTIONAL TYPE-

LT-5

HEADLAMP -CONVENTIONAL TYPE-

PFP:26010

System Description

EKS009LM

DESCRIPTION

The headlamps are controlled by the lighting switch which is built into the combination switch.
Power is supplied at all times

●

to lighting switch terminal 8

●

through 15A fuse (No. 41, located in the fuse and fusible link box), and

●

to lighting switch terminal 5

●

through 15A fuse (No. 42, located in the fuse and fusible link box).

LOW BEAM OPERATION

When the lighting switch is turned to the 2ND position and placed in LOW (“B”) position, power is supplied

●

from lighting switch terminal 10

●

to terminal 5 of the headlamp LH, and

●

from lighting switch terminal 7

●

to terminal 5 of the headlamp RH.

Terminal 3 of each headlamp supplies ground through body grounds E10 and E58.
With power and ground supplied, the low beams will illuminate.

HIGH BEAM OPERATION/FLASH-TO-PASS OPERATION

When the lighting switch is turned to the 2ND position and placed in HIGH (“A”) position or PASS (“C”) posi-
tion, power is supplied

●

from lighting switch terminal 9

●

to terminal 4 of headlamp LH, and

●

to combination meter terminal 20 (LHD models) or 7 (RHD models) for the HIGH BEAM indicator.

●

from lighting switch terminal 6

●

to terminal 4 of headlamp RH.

Ground is supplied to terminal 21 (LHD models) or 8 (RHD models) of the combination meter through body
grounds M16, M50 and M70.
Ground is supplied to terminal 3 of each headlamp through body grounds E10 and E58.
With power and ground supplied, the high beams and the HIGH BEAM indicator illuminate.

Nissan Primera P12. Manual - part 573