|
|
содержание .. 1102 1103 1104 1105 ..
PARKING BRAKE SHOE PB-9 < REMOVAL AND INSTALLATION > C D E G H I J K L M A B PB N O P 2. Remove the adjuster hole plug on the rotor. Using a screwdriver 3. Rotate the rotor to make sure that there is no drag. Install the 4. After adjusting the clearance of the rear shoes, adjust the park- • After replacing the shoes or the brake rotor or if the parking brake does not function well, perform the break-in procedure. PB-9, "Drum and Lining Break-in" Drum and Lining Break-in CAUTION: Do not carry out the break-in procedure excessively. Doing so may cause uneven or premature wear 1. Drive the unloaded vehicle on a safe, level and dry road. 2. Pull the parking brake control lever with a force of 147 N (15 kg-f, 33 lb-f). 3. While pulling the lever, continue to drive the vehicle forward 100 meters (328 ft) at approximately 35 km/h 4. Allow the parking brake to cool down for approximately five minutes. 5. Release the parking brake control lever and drive the vehicle under normal conditions for two minutes to 6. Repeat steps 1 through 5 three times and repeat just step 5 once more. 7. After performing the break-in procedure, check the stroke of the parking brake control lever. If it is out of Drum and Lining Break-in INFOID:0000000001724714 CAUTION: Do not carry out the break-in procedure excessively. Doing so may cause uneven or premature wear 1. Drive the unloaded vehicle on a safe, level and dry road. 2. Pull the parking brake control lever with a force of 147 N (15 kg-f, 33 lb-f). 3. While pulling the lever, continue to drive the vehicle forward 100 meters (328 ft) at approximately 35 km/h 4. Allow the parking brake to cool down for approximately five minutes. 5. Release the parking brake control lever and drive the vehicle under normal conditions for two minutes to 6. Repeat steps 1 through 5 three times and repeat just step 5 once more. 7. After performing the break-in procedure, check the stroke of the parking brake control lever. If it is out of WFIA0286E |