Mitsubishi Outlander XL. Manual - part 1334

ETACS-ECU FUNCTIONS AND CONTROLS

M25400000120USA0000010002

THEFT-ALARM FUNCTION (DEFAULT: WITH FUNCTION)

ZC6010800000

Door(s) is locked by the keyless
entry system or the keyless operation system
when the ignition switch is in the OFF position
(including lock operation by the timer lock)

Alarm history

output function

System disarmed

Ready to be
armed suspended

Ready to be armed

Ready to be triggered

Interior protection

Exterior protection

Protection suspended

· Ignition  switch (OFF )
· Rem oving the  key from the  key cylinder o r
the attestation of the  keyless ope ration  key is release d
· Simultaneous output (4 times) is complete

When a ny ope ration ab ove is don e

· Ignition switch (ACC)
· Inserting the key in the key cylinder
or keyless operation key is approved
· Previous alarm information exists
When all operations above are done

All doors and hood remain closed for 20 seconds

Door(s) or tailgate is opened by forced entry

In 10 seconds or 6 seconds

Hood is opened

All doors and hood
remains closed
for 2 seconds

In 180 seconds

Door(s) or tailgate is
opened by forced entry

In 175 seconds
or ignition switch is turned ON position

Operating  the  door  lock  with  the  keyless  entry
transmitter  or  keyless  operation  key  (except  when
locked by the key cylinder or door lock switch) makes
the  vehicle  ready  for  the  alarm,  and  a  "ping"  tone
starts. After 20 seconds, the incorrect door opening
(opening  door  or  liftgate  without  unlocking  by  the
keyless  entry)  sounds  the  room  alarm  with  "Beep"
tone  under  the  alarm  state.  After  10  seconds,  in
addition to the "Beep" tone, the headlight blink, and

the  horn  sounds  intermittently  for  175  seconds  to
execute  exterior  protection.  If  the  hood  is  opened
while the vehicle is under the alarm state or the interior
protection  state,  the  exterior  protection  will  be
executed immediately.

NOTE:

Availability of the theft-alarm and the

warning output can be adjusted by the
configuration function (Refer to P.54A-35).

54A-34

CHASSIS ELECTRICAL

THEFT-ALARM SYSTEM

ALARM HISTORY OUTPUT FUNCTION
If the interior protection or the exterior protection is activated
between the last OFF operation and the next ON operation of
the ignition switch, this function informs the driver by flashing the
theft-alarm indicator and by the tone alarm.

PANIC ALARM FUNCTION(DEFAULT: WITH FUNCTION)

With the ignition key removed from the ignition key
cylinder, when the panic button of transmitter is
pressed, the panic alarm is given off with flashing of

headlights and intermittent sounding of horn for 175
seconds.

NOTE:

Using the configuration function, the panic

alarm function can be enabled/disabled.(Refer
to P.54A-35)

CONFIGURATION FUNCTION

M25400000119USA0000010002

Using scan tool MB991958 adjusts the following
function. The programmed information is held even
when the battery is disconnected.

Adjustment

item

(scan

tool

MB991958 display)