|
|
ON-VEHICLE SERVICE SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR 54B-393 ON-VEHICLE SERVICE ADJUSTMENT FUNCTION <Vehicles with M1549002500593 According to the adjustmentmode entry conditions of • Keyless entry system hazard answerback • Vehicle speed-dependent wiper function • Headlamp automatic-shutdown function • Dimmer interior lamp control • Interior lamp automatic-shutdown function • Initialization of all functions (Returns to initial 1. Conditions for entering the adjustment mode i. Set each switch to the following state. • Hazard lamp switch: OFF • Diagnosis control: ON (Connect the • Key reminder switch: OFF (Insert the • Ignition switch: "LOCK" (OFF) position • Driver's door switch: OFF (driver's door ii. When the windshield washer switch is ON for more than ten seconds, the buzzer in the 2. Conditions for exiting the adjustment mode • Diagnosis control: OFF (Disconnect the • Key reminder switch: ON (Remove the • Ignition switch: Turning to any position other • Driver's door switch: ON (driver's door • When three minutes pass without • When the other warning buzzer output is 3. Configurations of various functions Function Adjustment procedure Keyless entry system hazard When the lock button of the transmitter is pressed twice continuously within • Function available: Buzzer sounds once. (Initial state) • Function not available: Buzzer sounds twice. When the unlock button of the transmitter is pressed twice continuously • Function available: Buzzer sounds once. (Initial state) • Function not available: Buzzer sounds twice. Vehicle speed-dependent When the windshield wiper mist switch is turned ON for more than two • Function available: Buzzer sounds once. (Initial state) • Function not available: Buzzer sounds twice. Headlamp When the passing switch is turned ON for more than two seconds with the • Function not available: Buzzer sounds twice. • Function available: (when the tail lamp illuminates with the ignition |