Mitsubishi Montero (2002-2004). Manual - part 993
SYMPTOM PROCEDURES <KEY INTERLOCK AND SHIFT LOCK MECHANISMS>
TSB Revision
SYMPTOM PROCEDURES
23Ad-83
STEP 3. Check the lock cam.
Q: Is the lock cam in good condition?
YES :
Go to Step 4.
NO :
Replace the lock cam. Refer to
.
Check that the selector lever can be moved
from "R" position to "P" position.
STEP 4. Check the fit of the key interlock cable.
Q: Is the key interlock cable installed correctly?
YES :
Go to Step 5.
NO :
Install the key interlock cable correctly.
Refer to
. Check that the ignition
key can not be turned to the "LOCK" (OFF)
position with the selector lever at "P"
position.
STEP 5. Check the key interlock cable.
Q: Is the key interlock cable in good condition?
YES :
Go to Step 6.
NO :
Replace the key interlock cable. Refer to
. Check that the ignition key can
not be turned to the "LOCK" (OFF) position
with the selector lever at "P" position.
STEP 6. Check the fit of the transmission control
cable.
Q: Is the transmission control cable installed
correctly?
YES :
Replace the steering lock cylinder
assembly. Refer to
and
.
Check that the ignition key can not be
turned to the "LOCK" (OFF) position with
the selector lever at "P" position.
NO :
Install the transmission control cable
correctly. Refer to
. Check that
the ignition key can not be turned to the
"LOCK" (OFF) position with the selector
lever at "P" position.
INSPECTION PROCEDURE 7: Ignition Key can be Turned to "LOCK" (OFF) Position when Selector at
Positions other than "P" Position.
.
TECHNICAL DESCRIPTION (COMMENT)
Lock cam, steering lock cylinder assembly, transmis-
sion control cable, or key interlock cable may be
defective.
.
TROUBLESHOOTING HINTS
• Malfunction of lock cam
• Malfunction of steering lock cylinder assembly
• Malfunction of transmission control cable
• Malfunction of key interlock cable
DIAGNOSIS
STEP 1. Check the connection of lock cam and
key interlock cable.
Q: Is the connection of lock cam and key interlock
cable in good condition?
YES :
Go to Step 2.
NO :
Repair the connection of lock cam and shift
lock cable. Check that the ignition key can
not be turned to the "LOCK" (OFF) position
with the selector lever at any position other
than "P" position.
STEP 2. Check the fit of the lock cam.
Q: Is the lock cam installed correctly?
YES :
Go to Step 3.
NO :
Install the lock cam correctly. Refer to
. Check that the ignition key can
not be turned to the "LOCK" (OFF) position
with the selector lever at any position other
than "P" position.
STEP 3. Check the lock cam.
Q: Is the lock cam in good condition?
YES :
Go to Step 4.
NO :
Replace the lock cam. Refer to
Check that the ignition key can not be
turned to the "LOCK" (OFF) position with
the selector lever at any position other than
"P" position.