|
|
AIR BAG MODULE DISPOSAL PROCEDURES TSB Revision SUPPLEMENTAL RESTRAINT SYSTEM(SRS) 52B-81 WARNING • Before deploying the air bag in this manner, first • The inflator will be quite hot immediately following for post-deployment handling instructions. • If the air bag module fails to deploy, do not go near 8. At a location as far away from the vehicle as possible, disconnect the two connected wires from each other, and 9. After deployment, dispose of the air bag module according to the Deployed Air Bag Module Disposal Procedures. DEPLOYMENT INSIDE THE VEHICLE (when disposing of a DANGER Wait at least 60 seconds after disconnecting the WARNING Battery posts, terminals and related accessories 2. Disconnect the negative (-) and positive (+) battery cables from the battery terminals, and then remove the battery from WARNING The side air bag modules for both the driver's side 3. To deploy the side air bag module: Remove the connection between the side air bag module connector (red two-pin) NOTE: If the air bag module connector is disconnected from AC003705AB BODY WIRING HARNESS SIDE AIR BAG |