Mitsubishi Space Star. Manual - part 18
ENGINE LUBRICATION –
On-vehicle Service <F9QT>
12-3
OIL FILTER REPLACEMENT
1.
After removing the engine oil filler cap, remove the engine
oil drain plug to drain the engine oil.
2.
Use the oil filter wrench to remove the engine oil filter.
3.
Clean the cylinder block side mounting surface.
4.
Apply a small amount of engine oil to the O-ring of a
new oil filter.
5.
Use the oil filter wrench to install the engine oil filter.
NOTE
Tightening torque: 10 – 14 Nm
6.
Fill with engine oil.
7.
Race the engine 2 – 3 times, and check to be sure that
no engine oil leaks from installation section of the oil filter.
O-ring