|
|
GARNISHES AND MOLDINGS EXTERIOR 51-10 2. Scrape off the double-sided tape with a resin spatula as much as possible. 3. Peel off the protection tape. 4. Use a shop towel moistened with 3M ™ AAD Part number 8906 or equivalent to wipe the body. . <Remove double-sided tape remaining on SIDE PROTECTOR molding with a resin spatula as much as possible. 2. Use a shop towel moistened with 3M ™ AAD Part number 8906 or equivalent to wipe the side protector molding 3. Remove only a small portion of the residual adhesive. 4. Apply primer to adherence area of the side protector molding, then adhere the double-sided tape as specified on INSTALLATION SERVICE POINT . >>A<< SIDE PROTECTOR MOLDING/ROOF DRIP 1. Tear off the double-sided tape backing paper. NOTE: If you attach the adhesive tape to the edge of the 2. Install the side protector molding/roof drip molding. NOTE: If the double-sided tape is difficult to affix in cold tem- − 60°C (104 − 140°F) before affixing the tape. 3. Firmly press in the side protector molding. AC000421 DOUBLE-SIDED TAPE AB AC000422 AC000657 |