Jeep Grand Cherokee WK. Manual - part 23

 

  Index      Jeep     Jeep Grand Cherokee WK - service repair manual 2005 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  21  22  23  24   ..

 

 

Jeep Grand Cherokee WK. Manual - part 23

 

 

1. Position the upper suspension arm (2) in the frame

rail bracket.

2. Install the mounting bolt (5) and nut (1) tighten to

129 N·m (95 ft. lbs.).

3. Position the upper suspension arm (4) in the axle

bracket.

4. Install the mounting bolt (3) and nut (2) tighten to

136 N·m (100 ft. lbs.).

5. Raise the fuel tank back into place and secure

(Refer to 14 - FUEL SYSTEM/FUEL DELIVERY/
FUEL TANK - INSTALLATION).

6. Remove the supports and lower the vehicle.

RIGHT SIDE

NOTE: All torques should be done with vehicle on the ground with full vehicle weight.

2 - 56

REAR

WK

1. Position the upper suspension arm (2) in the frame

rail bracket.

2. Install the mounting bolt (5) and nut (1) tighten to

129 N·m (95 ft. lbs.).

3. Position the upper suspension arm (4) in the axle

bracket.

4. Install the mounting bolt (3) and nut (2) tighten to

136 N·m (100 ft. lbs.).

5. Remove the supports and lower the vehicle.

SHOCK

DESCRIPTION

The top of the shock absorbers are bolted to the body. The bottom of the shocks are bolted to the axle brackets.
The standard shocks have conventional twin tube construction and are low pressure gas charged. Gas charging
prevents cavitation during rough road operation.

OPERATION

The shock absorbers dampen jounce and rebound motion of the vehicle over various road conditions and limit sus-
pension rebound travel.

WK

REAR

2 - 57

REMOVAL

1. Raise and support the vehicle. Position a hydraulic

jack under the axle to support the axle.

2. Remove the upper nut and bolt (1) from the frame

bracket.

3. Remove the lower nut and bolt from the axle

bracket (2). Remove the shock absorber (1).

2 - 58

REAR

WK

INSTALLATION

1. Install the shock absorber (2) in the frame bracket

and install the bolt (1) and nut.

2. Install the shock absorber (1) in the axle bracket

(2) and install the bolt and nut.

3. Tighten the upper mounting nuts to 95 N·m (70 ft.

lbs.). Tighten the lower mounting nuts to 115 N·m
(85 ft. lbs.).

4. Remove the supports and lower the vehicle.

SPRING

DESCRIPTION

The coil springs mount up in the wheelhouse which is part of the unitized body bracket. A rubber doughnut isolator
is located between the top and bottom of the spring. The isolators provide road noise isolation

OPERATION

The coil springs control ride quality and maintain proper ride height.

WK

REAR

2 - 59

 

 

 

 

 

 

 

Content   ..  21  22  23  24   ..