Infiniti EX35. Manual - part 1456

TM-212

< DISASSEMBLY AND ASSEMBLY >

[5AT: RE5R05A]

TRANSMISSION ASSEMBLY

• To prevent brake linings from cracking or peeling, do not

stretch the flexible band unnecessarily. When removing
the brake band, always secure it with a clip as shown in
the figure at right.
Leave the clip in position after removing the brake band.

• Check brake band facing for damage, cracks, wear or

burns.

16. Remove mid carrier assembly and rear carrier assembly as a

unit.

17. Remove mid carrier assembly from rear carrier assembly.

18. Remove needle bearing (front side) from mid carrier assembly.

19. Remove needle bearing (rear side) from mid carrier assembly.

SAT655

SCIA5017E

SCIA5697E

SCIA2805E

SCIA2804E

TRANSMISSION ASSEMBLY

TM-213

< DISASSEMBLY AND ASSEMBLY >

[5AT: RE5R05A]

C

E

F

G

H

I

J

K

L

M

A

B

TM

N

O

P

20. Remove bearing race from rear carrier assembly.

21. Remove needle bearing from rear carrier assembly.

22. Remove mid sun gear assembly, rear sun gear assembly and

high and low reverse clutch hub as a unit.

CAUTION:

Be careful to remove then with bearing race and needle
bearing.

23. Remove high and low reverse clutch assembly from direct clutch

assembly.

CAUTION:

Make sure that needle bearing is installed to the high and
low reverse clutch assembly edge surface.

24. Remove direct clutch assembly from reverse brake.

SCIA5175E

SCIA2803E

SCIA5018E

SCIA2306E

SCIA5019E

TM-214

< DISASSEMBLY AND ASSEMBLY >

[5AT: RE5R05A]

TRANSMISSION ASSEMBLY

25. Remove needle bearing from drum support.

26. Remove snap ring (1) from A/T assembly harness connector

(A).

27. Push A/T assembly harness connector (A).

CAUTION:

Be careful not to damage connector.

28. Remove clips (1).

29. Remove oil pan (2) and oil pan gasket.

30. Remove magnets (1) from oil pan.

SCIA5198E

JPDIA0007ZZ

JPDIA0008ZZ

3

: Drain plug

: Front

: Oil pan mounting bolt

SCIA8117E

JPDIA0009ZZ

TRANSMISSION ASSEMBLY

TM-215

< DISASSEMBLY AND ASSEMBLY >

[5AT: RE5R05A]

C

E

F

G

H

I

J

K

L

M

A

B

TM

N

O

P

31. Disconnect A/T fluid temperature sensor 2 connector (A).

CAUTION:

Be careful not to damage connector.

32. Disengage terminal clips (

).

33. Disconnect revolution sensor connector (A).

CAUTION:

Be careful not to damage connector.

34. Disengage terminal clip (

).

35. Remove bolts (A), (B) and (C) from control valve with TCM.

36. Remove control valve with TCM from transmission case.

CAUTION:

When removing, be careful with the manual valve notch and
manual plate height. Remove it vertically.

37. Remove A/T fluid temperature sensor 2 (1) with bracket (2) from

control valve with TCM.

SCIA8124E

JPDIA0011ZZ

: Front

SCIA8077E

SCIA5260E

: Bolt

JPDIA0013ZZ