|
|
ADP-118 < COMPONENT DIAGNOSIS > TELESCOPIC MOTOR TELESCOPIC MOTOR Description INFOID:0000000003134764 • The telescopic motor is installed to the steering column assembly. Component Function Check INFOID:0000000003134765 1. CHECK FUNCTION 1. Turn ignition switch ON. 2. Select “TELESCO MOTOR” in “Active test” mode with CONSULT-III. 3. Check the telescopic motor operation. Is the operation of relevant parts normal? YES >> INSPECTION END NO >> Perform diagnosis procedure. Refer to ADP-118, "Diagnosis Procedure" . Diagnosis Procedure INFOID:0000000003134766 1. CHECK TELESCOPIC MOTOR POWER SUPPLY 1. Turn ignition switch OFF. 2. Disconnect tilt & telescopic motor connector. 3. Turn the ignition switch ON. 4. Perform “Active test” (“TELESCO MOTOR”) with CONSULT-III 5. Check voltage between tilt & telescopic motor harness connector and ground. Is the inspection result normal? YES >> Replace telescopic motor. (Built in steering column assembly.) NO >> GO TO 2. 2. CHECK TELESCOPIC MOTOR CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect automatic drive positioner control unit and tilt & telescopic motor connector. 3. Check continuity between automatic drive positioner control unit harness connector and tilt & telescopic Test item Description TELESCO MOTOR OFF Steering telescopic Stop FR Forward RR Backward (+) (-) Condition Voltage (V) (Approx.) Tilt & telescopic motor Connector Terminal M49 1 Ground TELESCOPIC MO- OFF 0 FR (forward) 0 RR (backward) Battery voltage 2 OFF 0 FR (forward) Battery voltage RR (backward) 0 |