|
|
If the ON switch is not depressed within five seconds after entering the diagnostics mode, the module The speed control indicator lamp will flash as each switch is depressed. Press each switch in the sequence 3. A lamp flash with the last button (SET/ACCEL) indicates that the static test passed. If the lamp does not flash with the last button and there are no additional flashes of the lamp, the switch is defective. If the lamp does not flash with the last button, and additional flashes occur, follow the chart below for { 2 flashes - BPP defective, circuit is defective, brake applied, CPP switch or jumper (if equipped). { 3 flashes - deactivator switch is open or circuit defective. { 4 flashes - vehicle speed signal is out of range or circuit is defective 4. Immediately (.25 second delay) after the static test, the speed control servo does a dynamic test by automatically actuating the throttle lever from 8 mm (0.315 in) to 12 mm (0.472 in) of travel from the idle 5. Return the ignition switch to the OFF position and proceed to the Symptom Chart. Symptom Chart NOTE: There will be a slight delay when the last button is pressed and the lamp
2003 Ford Pickup F150 2003 ACCESSORIES AND BODY, CAB Vehicle Speed Control - F150 Pickup
|