3
CF65/75/85 series
Disassembly and assembly
PTO
5-9
5.3 VERSIONS WITH AND WITHOUT DRIVE FLANGE AND SHIFT CONTROL
Version without prop shaft flange and shift
control
1.
Note:
Fit a gasket between the drive housing and
PTO housing. Remember the oil channel in
the gasket.
2.
Fit a gasket and cover on the front of the
drive housing and tighten the attachment
bolts to the specified torque. See “Technical
data”.
3.
Fit a guide block, gasket and cover to the
side of the drive housing. Tighten the
attachment bolts to the specified torque.
See “Technical data”.
Version with prop shaft flange and shift
control
1.
Note:
Fit the gasket and drive housing over the
studs against the PTO housing.
2.
Fit a needle bearing into the prop shaft.
3.
Fit the short drive shaft and bearing against
the drive housing.
4.
Fit the cover with gasket and oil seal
against the drive housing and tighten the
attachment nuts to the specified torque. See
“Technical data”.
5.
Fit the drive flange with locking plate and
O-ring and tighten the attachment bolt to the
specified torque. See “Technical data”.
6.
At the rear of the selector housing, fit a
sealing cap. Fit the selector housing with
gasket against the drive housing and tighten
the attachment bolts to the specified torque.
See “Technical data”.
13
ᓻ 200337