|
|
3 CF65/75/85 series Removal and installation PTO 4-3 5. Fit the engine bracket attachment bolts. 6. Fit the entire PTO to the flywheel housing. 7. Fit the flywheel. 8. Fit the clutch release assembly. 9. Fit the gearbox. 4.3 REMOVAL AND INSTALLATION, NH/1 AND NL/1 PTO, B VERSION Removing NH/1 and NL/1 PTO, B version Drain as much gearbox oil as necessary 2. Remove the electrical connector and air 3. Remove the drive flange, which is mounted 4. Remove the attachment nuts connecting the 5. If necessary, remove the intermediate shaft. Installing NH/1 and NL/1 PTO, B version If necessary, install the intermediate shaft. 2. Install the gasket over the studs. 3. Install the PTO with needle bearing onto the 4. Fit the attachment nuts onto the studs of the 5. Connect the electrical connector and air 6. Install the drive flange against the 7. Check the oil level in the gearbox. 13 ᓻ 200337 |