Index Chrysler Chrysler TOWN & COUNTRY, VOYAGER, Dodge Caravan - service repair manual 2001-2007 year
|
|
(5) Install bolts attaching upper hinge to sliding door. (6) Remove padded block from between sliding door and roof rail. (7) Place stop bracket in position on vehicle. upper roller bracket (Fig. 23). (9) Verify sliding door alignment and operation. Adjust as necessary. (Refer to 23 - BODY/DOORS - OUTSIDE HANDLE CABLE REMOVAL NOTE: For power sliding door procedures refer to (1) Disconnect and isolate the negative battery cable. (2) Remove stop bumper (Refer to 23 - BODY/ DOORS - SLIDING/STOP BUMPER - REMOVAL). (3) Remove the appropriate side door trim panel. (Refer to 23 - BODY/DOORS - SLIDING/TRIM (4) Peel watershield away from adhesive around perimeter of inner door panel. CAUTION: Make note of cable routing and foam (5) Trace the outside handle cable along its routing path and disconnect from its retaining clips. (6) Disconnect the outside handle cable from the latch assembly. Gently pry cable sleeve retainer out (7) Disconnect the outside handle cable from the handle assembly. Gently pry cable sleeve retainer out (8) Remove the outside handle cable from the side door. INSTALLATION NOTE: For power sliding door procedures refer to (1) Match the replacement cable up against the old cable to verify the correct part. (2) Position the outside handle cable on the side door. (3) Connect the outside handle cable on the handle assembly. Hook the swedged cable end on the handle NOTE: The outside handle cable is marked with red (4) Connect the outside handle cable on the latch assembly. Hook the swedged cable end on the latch (5) Trace the outside handle cable along its routing path and install on its retaining clips and position CAUTION: Be certain replacement cable is routed (6) Place the watershield into position and press securely to adhesive making sure to properly route (7) Install the appropriate side door trim panel on the vehicle. (Refer to 23 - BODY/DOORS - SLIDING/ (8) Install stop bumper (Refer to 23 - BODY/ DOORS - SLIDING/STOP BUMPER - INSTALLA- (9) Connect the negative battery cable. Fig. 24 SLIDING DOOR UPPER HINGE 1 - SLIDING DOOR UPPER HINGE 23 - 36 DOORS - SLIDING RS UPPER HINGE (Continued) |