|
|
(P0715) INPUT SENSOR MISMATCH (CONTINUED) When Monitored and Set Condition • When Monitored: Engine speed greater than 450 RPM, no engine speed DTCs, no TCM undervoltage system • Set Condition: If the speed difference between the N2 and N3 input speed sensors is greater than 150 RPM. POSSIBLE CAUSES SPEED SENSOR DTCS PRESENT INTERNAL TRANSMISSION TRANSMISSION CONTROL MODULE For a complete Transmission Control Module Circuit Diagram, (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTO- Diagnostic Test 1. PRE-DIAGNOSTIC CHECK OUT Note: Low fluid level can be the cause of many transmission Note: Always perform diagnostics with a fully charged battery to T , read Engine DTCs. Check and repair all engine DTCs prior to performing transmission symptom diagnostics. With the DRB III T , read and record all Transmission DTCs. Note: Check connectors - Clean/repair as necessary. Poor pin to Most DTCs set on start up but some must be set by driving the vehicle such that all diagnostic monitors have run. Note: Check for any Technical Service Bulletins that may apply. Perform this procedure prior to Symptom diagnosis. Continue Go To 2 ZH NAG1 - ELECTRICAL DIAGNOSTICS 21 - 93 |