|
|
B210D-BATTERY VOLTAGE LOW For a complete wiring diagram Refer to Section 8W. • When Monitored: • Set Condition: Possible Causes VEHICLE CHARGING SYSTEM PARK ASSIST MODULE Diagnostic Test 1. CHECK FOR ACTIVE DTC: B210D-BATTERY VOLTAGE LOW Turn the ignition on. Apply the vehicle park brake. Shift the transmission into reverse. With the scan tool, record and erase Park Assist Module DTCs. Wait 30 seconds. With the scan tool, read Park Assist Module DTCs. Is DTC: B210D-BATTERY VOLTAGE LOW active? Yes >> Go To 2 No >> The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chaffed, pierced, pinched, and partially broken wires. Also Perform BODY VERIFICATION TEST - VER 1. (Refer to BODY VERIFICATION TEST - VER 1). 2. VERIFY OPERATION OF THE VEHICLE CHARGING SYSTEM NOTE: Troubleshoot any PCM charging/cranking DTCs before proceeding. NOTE: Ensure the battery is fully charged. Are any charging system DTCs present? Yes >> (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING) for the diagnostic test procedures. No >> Replace the Park Assist Module in accordance with the service information. Perform BODY VERIFICATION TEST - VER 1. (Refer to BODY VERIFICATION TEST - VER 1). 8B - 30 CHIME/BUZZER - ELECTRICAL DIAGNOSTICS LX |