|
|
Fig. 185: View Of Oil Feed Pipe Bolt, Washer & Pipe 1. Remove the turbocharger. Refer to Turbocharger Replacement. 2. Remove the turbocharger oil feed pipe bolt. 3. Remove the oil feed pipe and washer. Installation Procedure
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 6.6L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 186: View Of Oil Feed Pipe Bolt, Washer & Pipe NOTE: Do not twist the turbocharger oil feed pipe. Twisting of the feed
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 6.6L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
1. Position the oil feed pipe and a NEW washer into place. 2. Install the oil feed pipe bolt. Tighten: Tighten the bolt to 34 N.m (25 lb ft). 3. Install the turbocharger. Refer to Turbocharger Replacement. AIR CONDITIONING (A/C) COMPRESSOR AND POWER STEERING PUMP BRACKET Removal Procedure IMPORTANT: Lubricate the NEW washer with diesel fuel before installing. NOTE: Refer to Fastener Notice .
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 6.6L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 187: View Of Left Side Idler Pulley & Bolt (Dual Generators) 1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (w/Single Battery) or Battery Negative Cable Disconnection and
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 6.6L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|
|
|