|
|
Content .. 2599 2600 2601 2602 ..
Fig. 23: Identifying VSS And O-Ring Seal 1. Coat a NEW O-ring seal with a thin film of Synchro-mesh transmission fluid GM P/N 12345349 (Canadian P/N 10953465), or equivalent. 2. Install the VSS and O-ring seal. Tighten: Tighten the VSS to 16 N.m (12 lb ft). NOTE: Refer to Component Fastener Tightening Notice .
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
Fig. 24: Locating HO2S Electrical Connector At Harness (Manual 2WD) 3. Connect the VSS electrical connector (1). 4. Lower the vehicle. TRANSMISSION FLUID REPLACEMENT Tools Required J 36511 Oil Fill/Drain Plug Hex Bit (17 mm)
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
Removal Procedure Fig. 25: View Of Oil Fill Plug 1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle . 2. Using J 36511 remove the oil fill plug.
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
Fig. 26: View Of Oil Drain Plug 3. Place a suitable drain pan under the transmission in order to catch the drained transmission fluid. 4. Using J 36511 remove the oil drain plug. 5. Remove any old sealant from the transmission housing. Installation Procedure
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
Content .. 2599 2600 2601 2602 ..
|
|
|