Acura TSX / Honda Accord CL. Manual - part 95

 

  Index      Acura     Acura TSX 2004-2008 / Honda Accord CL 2006-2008 - service repair manual

 

Search            copyright infringement  

 

 

 

 

 

 

 

 

 

Content   ..  93  94  95  96   ..

 

 

Acura TSX / Honda Accord CL. Manual - part 95

 

 

Fig. 56: Applying Multipurpose Grease To The Regulator 

11. Install the glass and regulator in the reverse order of removal, and note these items: 

z

Never use any kind other than the corrosion resistant bolts where these special bolts were installed 
in. If other bolts are used, electrolysis may accelerate corrosion around tightening points, resulting 
in loosening of the joints.  

z

Roll the glass up and down to see if it moves freely without binding.  

z

Make sure that there is no clearance between the glass and glass run channel when the glass is 
closed.  

z

Adjust the position of the glass as necessary (see FRONT & REAR DOOR GLASS 
ADJUSTMENT
 ).  

z

Check for water leaks (see step 7 of FRONT & REAR DOOR GLASS ADJUSTMENT ).  

z

Test-drive and check for wind noise and rattles.  

z

When reinstalling the door panel, make sure the plastic cover is installed properly and sealed 
around its outside perimeter to seal out water. 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

  

 

REAR DOOR GLASS OUTER WEATHERSTRIP REPLACEMENT

1. Remove the door panel (see REAR DOOR PANEL REMOVAL/INSTALLATION ).  

2. Remove the screw (A) from the front edge of the door, and screws (B) fastening the rear portion of the 

door weatherstrip (C), sash, and the door outer molding (D). 

NOTE:

z

Once you remove the door glass outer weatherstrip, replace it with a new 
one because it will bend during removal.  

z

Put on gloves to protect your hands.  

z

Take care not to scratch the door.  

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

  

 

Fig. 57: Removing Door Outer Molding Fasteners

3. Starting at the front, pull the door glass outer weatherstrip (A) up at each portion where the inner molding 

(B) catches the inside edge of the window slot. Take care not to bend the door outer molding (C). 

Fig. 58: Removing Door Outer Molding 

4. First slide the door glass outer weatherstrip (A) forward slightly, detach the rear clip (B) by pulling the 

front of the weatherstrip up, then remove the weatherstrip. 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

  

 

Fig. 59: Removing Door Glass Outer Weatherstrip 

5. Install a new weatherstrip in the reverse order of removal.  

REAR DOOR OUTER MOLDING REPLACEMENT 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

  

 

 

 

 

 

 

 

 

Content   ..  93  94  95  96   ..