Acura TSX / Honda Accord CL. Manual - part 96

1. Remove the screws fastening the rear of the door weatherstrip (A), sash, and the door outer molding (B). 

NOTE:

z

Once you remove the door outer molding, replace it with a new one 
because it will bend during removal.  

z

Put on gloves to protect your hands.  

z

Take care not to scratch the door.  

z

When prying with a flat-tip screwdriver, wrap it with protective tape to 
prevent damage.  

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

  

 

Fig. 60: Removing The Screws Fastening The Rear Of The Door Weatherstrip 

2. Pry the front clip with a flat-tip screwdriver. 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

  

 

Fig. 61: Prying The Front Clip 

3. While removing the upper edge of the door outer molding (A) from the edge of the sash, cut the double-

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

  

 

sided adhesive tapes (B) with a utility knife, then remove the molding. 

4. Scrape off the remaining double-sided adhesive tape from the sash, then clean the sash surface with a 

sponge dampened in alcohol.  

5. Install new door outer molding in the reverse order of removal, and note these items. 

z

Push the clip and the adhesive portions into place securely.  

z

Make sure the upper and lower sides of the molding are catching the edges of the sash properly.  

z

Make sure the seal (C) at the bottom of the molding is under the door glass outer weatherstrip (D).  

REAR DOOR WEATHERSTRIP REPLACEMENT 

1. At the B-pillar, remove the door stop mounting bolt (A). 

NOTE:

z

Take care not to scratch the door.  

z

Use a clip remover to remove the clips. 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX