|
|
|
содержание .. 422 423 424 425 ..
b. Disconnect connector (B), and measure the resistance between connector (A) and chassis ground, and between (B1) and chassis ground as shown in Fig. 15. The measured resistance between connector (B1) and chassis ground is 1Q or less. The short to Fig. 15: Resistance Check Method - Circuit Diagram SYMPTOM TROUBLESHOOTING GUIDE CHART SYMPTOM TROUBLESHOOTING GUIDE CHART MAIN SYMPTOM DIAGNOSTIC PROCEDURE ALSO CHECK FOR Unable to start 1. Test the battery 2. Test the starter 3. Inhibitor switch (A/T) or clutch start switch (M/T)
Unable to start 1. Test the battery 2. Check the fuel pressure 3. Check the ignition circuit 4. Troubleshooting the immobilizer system (In case of immobilizer DTC Low compression Intake air leaks Slipped or broken timing belt Contaminated fuel Difficult to start 1. Test the battery 2. Check the fuel pressure 3. Check the ECT sensor and circuit (Check DTC) 4. Check the ignition circuit DTC Low compression Intake air leaks Contaminated fuel Weak ignition spark 1. Check the fuel pressure
2008 Kia Sedona 2008 ENGINE PERFORMANCE Fuel System - General - Sedona
Microsoft
Saturday, May 22, 2010 3:59:43 PM Page 21 © 2006 Mitchell Repair Information Company, LLC. |