|
|
6. DETERMINE THE CORRECT REPAIR NOTE: The Occupant Classification Module (OCM) and the Passenger Seat Bladder and Cushion Kit are the • If possible, check the vehicle’s repair history. • The Service Kit wiring harness uses tamper resistant material on the harness connector. Inspect for the tamper Does the seat have a Bladder and Cushion Service Kit? Yes >> WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two min- WARNING: If the Occupant Classification Module (OCM) is dropped at any time, it must be replaced. Failure NOTE: The Bladder and Cushion Kit are calibrated as an assembly. Do not disconnect the Bladder from the Replace OCS Bladder and Cushion Kit in accordance with the Service information. Perform SYSTEM VERIFICATION REQUIRED test. Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1. No >> WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two min- WARNING: If the Occupant Classification Module (OCM) is dropped at any time, it must be replaced. Failure NOTE: The Bladder and Cushion Kit are calibrated as an assembly. Do not disconnect the Bladder from the Replace the OCM in accordance with the Service Information. Perform SYSTEM VERIFICATION REQUIRED test. Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1. 7. TEST FOR AN INTERMITTENT CONDITION With the scan tool, monitor for active codes while performing the following: NOTE: The Passenger Airbag On-Off Indicator will illuminate within one second of a fault becoming active. • Verify that all connectors are completely seated and locked. • Wiggle the wiring harness and connectors of the related circuit. In the previous steps you have attempted to recreate the conditions responsible for setting the DTC in question. NOTE: Some DTCs require up to one minute to mature. Does the scan tool display any active DTCs? Yes >> Select the appropriate diagnostic procedure from the Table of Contents in this section. No >> No problem found at this time. Erase all codes before returning the vehicle to the customer. 8O - 122 RESTRAINTS - ELECTRICAL DIAGNOSTICS KJ |